Machine Specifications; Milling Machine; Delivery Scope - Amann Girrbach Ceramill Motion 3 Modo De Empleo

4

Machine Specifications

4.1

Milling machine

This User Manual describes different mod-
els of the milling machine. Therefore, the
representations can deviate from the
actual appearance of the machine.
4.1.1

Delivery Scope

_ Digital milling machine
_ Mains cable
_ USB cable (5m)
_ Network cable (5m)
_ Control cable, extraction
_ Service unit including compressed-air hoses
_ Service set for spindle
_ Torque wrench for collet
_ CAM software
_ Auto-calibration set
▪ Calibration blank
▪ Calibration pin
_ Set for manual calibration
▪ Test blank
▪ Cutter 2.5 mm
▪ Slide caliper
_ Torque wrench (4 Nm) for blank holder
_ Torque wrench (3 Nm) for fastening blank
_ Blank holder 98 mm
_ Extractor adapter
_ Extraction hood
_ Drain sieve
_ Cleaning brush
_ Cleaning brush
M A C H I N E S P E C I F I C A T I O N S
The milling machine is supplied with an automatic
calibration set.
To check the zero point, a test milling run was car-
ried out at the factory prior to delivery. Milling
chips may have remained from this. These are no
reason for rejection, as the check process contrib-
utes significantly to the accuracy of the machine.
▷ After unpacking, check the machine for com-
pleteness and possible transport damages.
Please claim any transport damages immedi-
ately with your supplier.
E N
37