Starting-Up The Milling Machine - Amann Girrbach Ceramill Motion 3 Modo De Empleo

I N S T A L L A T I O N
5.6

Starting-up the milling machine

E N
Calibration of the milling machine is advis-
able after installation for commissioning,
but not mandatory. The milling machine
can adjust itself via auto-calibration. This
process can be started on the display
under
are explained on the display. In the follow-
ing, the calibration is described via the
milling process. This is to be performed in
exceptional cases and only upon support
request.
The cutters can be inserted in all slots of the mill-
ing machine. By means of the integrated RFID
chip, the machine automatically recognizes the
cutter. When a standard tool has reached its wear
limit, the milling machine automatically accesses
the respective sister tool.
Fig. 10 Tool holder
▷ For calibration, insert the "760660 Roto RFID
2.5 ZI" cutter from the delivery scope.
48
Maintenance
. All necessary steps
▷ Insert the selected blank into the holder in the
milling machine.
Fig. 11 Inserting a blank
▷ Fasten the blank with the bayonet lock.
▷ Lock the screws with the provided torque
wrench.
Fig. 12 Tightening a blank
▷ Mount the respective hood.
▪ Extraction hood for dry processing
▪ Splash guard for wet processing