Installation Of The Cam And Milling Machine Software - Amann Girrbach Ceramill Motion 3 Modo De Empleo

I N S T A L L A T I O N
Requirements on air purity for the spindle
When another service unit than the one supplied is
E N
to be used, the following connection conditions
according to
DIN-ISO 8573-1 must be ensured:
_ Solid contaminants: Class 3
(particle size max. 5 μm, particle density max.
3
5 mg/m
_ Water content: Class 4
(max. pressure dew point +3 °C, water content
max. 6000 mg/m
_ Total oil content: Class 2;
(max. oil content 0.1 mg/m
Recommended extraction system require-
ments
When another extraction system is to be used, it
must meet the following requirements:
_ Extraction capacity: 240 m
_ Suitability for zirconium-oxide dusts
_ HEPA microfilter (97.97 %), filter class H12,
dust category M
The connection of the extraction hose to the
machine is made with an adapter (in delivery
scope). The adapter fits extraction hoses with a
38 mm interior diameter.
46
)
3
)
3
)
3
/h
5.4 Installation of the CAM and milling
machine software
▷ Insert the CAM software CD-ROM into the drive
of the PC.
The software to be installed is on the CD.
▷ Execute the ".exe" file and follow the directions
on the monitor.
Connecting the interfaces
1 2 3
5 6
100/115/230VAC
I
0
230V T3.15 A
100/115V T6.30 A
Fig. 7 Interfaces on the rear side of the milling
machine
1 Slot for SD memory card
2 Ethernet interface
3 USB data port
4 Control interface for extraction
5 Main switch
6 Power supply connection
▷ Make sure that the main switch [6] of the milling
machine is in the 0 position.
▷ Check if the SD memory card is properly seated
in the slot [1] on the rear side of the milling
machine.
▷ Connect the mains cable to power supply con-
nection [7] of the milling machine as well as to a
mains socket outlet.
4