Establishing The Network; Connection - Amann Girrbach Ceramill Motion 3 Modo De Empleo

▷ Connect the control cable to the control inter-
face for extraction [5] on the rear side of the
milling machine and to the interface on the rear
side of the extraction system.
For installation with supply unit:
1
Fig. 8 Connections of the supply unit
1 Control interface for supply unit
▷ Connect the control cable to the control inter-
face for the supply unit on the rear side of the
milling machine ([4] in Fig. 7) and to the supply
unit ([1] in Fig. 8).
Connecting to the PC
▷ Connect a USB cable to the USB interface ([3] in
fig. 7) of the milling machine and to a free USB
port of the PC.
The maximum permitted length of the USB
cable is 5 m.
▷ Insert the CAM Dongle in a free USB port on the
rear side of the PC.
Fig. 9 CAM Dongle
I N S T A L L A T I O N
5.5 Establishing the Network Connec-
tion
To establish the network connection, the
milling machine and the PC must first be
connected via USB.
▷ Connect the Ethernet interface ([2] in Fig. 7) of
the milling machine with the PC or with the net-
work using a network cable.
The maximum permitted length of the network
cable to the PC or to the network router is 100
m.
▷ Switch the milling machine on.
▷ Start the milling machine software.
▷ After initializing the milling machine in the soft-
Settings
ware under >
connection type from USB to Ethernet and
adapt the IP address, if required (see descrip-
tion of the milling machine software).
▷ Switch the milling machine off and then on
again.
▷ Initialize the milling machine in the software.
▷ After the software has detected the Ethernet
connection, remove the USB cable.
When operating via a network, up to eight
machines can be connected and controlled
via the CAM software.
The PC and the milling machine must both
be in the same sub-network.
Communication
, set the
E N
47