Cleaning And Maintenance; Milling Machine - Amann Girrbach Ceramill Motion 3 Modo De Empleo

C L E A N I N G A N D M A I N T E N A N C E
8

Cleaning and Maintenance

E N
The milling machine has interactive clean-
ing workflows in the menu area
nance
The following applies for all cleaning runs:
_ When due, they are automatically indicated on
the milling machine display.
_ They can be conveniently called up and carried
out, documented with pictures, step by step on
the display of the milling machine.
_ They are documented.
8.1

Milling machine

8.1.1 Cleaning
The milling machine must be cleaned after each
working day.
▷ Empty the swarf sieve frequently, especially
when wet grinding plastic.
When the swarf sieve is too full, it is possible
that the coolant/lubricant will not drain off.
Cleaning after dry processing
NOTE:
Zirconia dust is abrasive!
▷ Clean the window in the door carefully, using
only a soft cloth; do not scrub or scour.
▷ Open the milling chamber door.
▷ Replace the extraction hood with the cleaning
hose with brush head.
▷ On the display of the milling machine, activate
Exhaustion
58
.
Sealing air
and .
▷ If required, remove the swarf sieve and dispose
of accumulated milling dust/shavings away
from the machine.
In this manner, the filter bag in the extraction
Mainte-
system will not fill up as quickly and can be used
longer.
▷ Thoroughly vacuum out the milling chamber
with the cleaning hose.
▷ Carefully clean the RFID read/write unit with a
clean cloth.
▷ Carefully clean the tool shanks.
Residual zirconia dust from dry processing
can clog the filter bag in case of subse-
quent wet processing.
▷ On the display of the milling machine, deacti-
vate Exhaustion
Cleaning after wet processing
NOTE:
Possible machine damage through dried-in cool-
ant/lubricant and bound in milling dust.
After wet processing:
▷ Clean and dry the milling chamber prior to
downtimes lasting several hours.
NOTE:
The extraction is not designed for wet vacuum-
ing. The extraction may not be used for cleaning
the interior after wet processing!
▷ Remove shavings/chips manually.
NOTE:
The milling chamber may only be cleaned with
water.
▷ Do not use cleaning agents.
and Sealing air .