Before Setting Oven Controls - IKEA CIRKULERA Manual

Before Setting oven ControlS

Before Setting oven ControlS
oven vent location (some models)
The oven vent is located under the control panel.
When the oven is on, warm air passes through
this vent. This venting is necessary for proper air
circulation in the oven and good baking results.
Do not block the oven vent. Never close off the
openings with aluminum foil or any other material.
Steam or moisture may appear near the oven vent.
This is normal.
the Cooling fan (some models)
The cooling fan operates during cooking. Air is
expelled through the vents between the oven door
and the control panel as shown in Figure 7.
figure 7: Cooling fan location
WArning
Protective Liners — Do not use aluminum foil or
any other material or liners to line the oven bot-
tom, walls, racks or any other part of the range.
Doing so will alter the heat distribution, produce
poor baking results, and possibly cause permanent
damage to the oven interior. Improper installation
of these liners may result in risk of electric shock
or fire. During self clean, temperatures in the oven
will be hot enough to melt foil.
CAUtion
Always use pot holders or oven mitts when using
the oven. When cooking, the oven interior, oven
exterior, oven racks, and cooktop will become very
hot which can cause burns.
Remove all oven racks before starting a self clean
cycle. If oven racks are left inside the oven during
a cleaning cycle, the slide ability of the oven racks
may be damaged and all of the oven racks will
lose their shiny finish.
To prevent possible damage to the oven, do not
attempt to close the oven door until all the oven
racks are fully positioned back inside the oven
cavity.
16
type of oven rack
figure 8: type of oven racks
• flat oven racks may be used for most cooking
needs and may be placed in most oven rack
positions.
removing, replacing, and Arranging
flat racks
Always arrange the oven racks when the oven is
cool.
To remove - Pull the oven rack straight forward
until it reaches the stop position. Lift up front of
oven rack slightly and slide out.
To replace - Place the oven rack on the rack guides
on both sides of oven walls. Tilt the front of oven
rack upward slightly and slide the oven rack back
into place. Be sure oven racks are level before
using.
EN