Keypad Mode And Menu Displays - Omron Q2 Serie Instrucciones De Instalación Y Funcionamiento

Symbol Name
STOP Key
G
Left Arrow Key
Up Arrow Key/Down
Arrow Key
/
H
Right Arrow Key (RESET)
ENTER Key
RUN Key
I
J
USB Terminal
K RJ-45 Connector
L Clock Battery Cover
WARNING Sudden Movement Hazard. The drive may start unexpectedly if switching control sources when setting b1-07
= 2 [LO/RE Run Selection = Accept RUN]. Clear all personnel from rotating machinery and electrical connections prior to
switching control sources. Failure to comply may cause death or serious injury.
■

Keypad Mode and Menu Displays

Note:
• Energize the drive with factory defaults to show the Initial Setup screen. Push
–Select [No] from the [Show Initial Setup Screen] setting to skip Initial Setup screen during power up.
• Push
from the Home screen to show drive monitors.
• Push
to set d1-01 [Reference 1] when the Home screen shows U1-01 [Frequency Reference] in LOCAL Mode.
• The keypad will show [Rdy] when the drive is in Drive Mode. The drive is prepared to accept a Run command.
• The drive will not accept a Run command in Programming Mode in the default setting. Set b1-08 [RUN@PRG Mode Selection] to
accept or reject a Run command from an external source while in Programming Mode.
–Set b1-08 = 1 [NoRUN@Program] to reject the Run command from an external source while in Programming Mode (default).
–Set b1-08 = 2 [RUN@Program] to accept the Run command from an external source while in Programming Mode.
–Set b1-08 = 3 [Program@Stop only] to prevent changes from Drive Mode to Programming Mode while the drive is operating.
TOMPYEUOQ2A03C AC Drive Q2A Installation and Operation Instructions
Stops drive operation.
Note:
Uses a stop-priority circuit. Push
[STOP Key Selection of Function = Disabled] to disable the priority in
• Moves the cursor to the left.
• Back to the previous screen.
• Scrolls up or down to display the next item or the previous item.
• Selects parameter numbers, and increments or decrements setting values.
• Moves the cursor to the right.
• Continues to the next screen.
• Restarts the drive to clear a fault.
• Enters parameter values and settings.
• Selects menu items to move the user between keypad displays.
• Selects each mode, parameter, and set value.
Starts the drive in LOCAL Mode.
Starts the operation in Auto-Tuning Mode.
Note:
Push on the keypad to set the drive to LOCAL Mode before operating the motor with the keypad.
Insertion point for a USB cable (USB 2.0, type: A - mini-B). Use the USB cable to connect the drive to a PC.
Connects to the drive using an RJ-45 8-pin straight through UTP CAT5e cable or keypad connector.
Remove this cover to install or replace the clock battery.
Function
to stop the motor even when a Run command is active at MFDI terminals. Set o2-02 = 0
.
(Home) to show the HOME screen.
1 English
EN
11