China Rohs Compliance - Omron Q2 Serie Instrucciones De Instalación Y Funcionamiento

6 Attachments
The output turns OFF and the motor coasts to stop. Fault relay output terminal 1NO-1CM turns ON, and 1NC-
1CM turns OFF.
2 : Fast Stop (C1-09)
The drive stops the motor in the deceleration time set in C1-09 [Fast Stop Time]. Fault relay output terminal 1NO-
1CM turns ON, and 1NC-1CM turns OFF.
3 : Alarm Only
The keypad shows oH3, and operation continues. The output terminal set for Alarm [H2-01 to H2-03 = 4] turns
ON.
L1-04 Motor oH FLT Reaction Select
No.
Name
(Hex.)
L1-04 Motor oH FLT Reaction
Select
(0483)
0 : Ramp->Stop
The drive ramps the motor to stop in the deceleration time. Fault relay output terminal 1NO-1CM turns ON and
1NC-1CM turns OFF.
1 : Coast->Stop
The output turns OFF and the motor coasts to stop. Fault relay output terminal 1NO-1CM turns ON, and 1NC-
1CM turns OFF.
2 : Fast Stop (C1-09)
The drive stops the motor in the deceleration time set in C1-09 [Fast Stop Time]. Fault relay output terminal 1NO-
1CM turns ON, and 1NC-1CM turns OFF.
◆

China RoHS Compliance

The China RoHS mark is displayed on products containing six specified hazardous substances that are in excess
of regulatory limits, based on the "Administrative Measures for the Restriction of the Use of Hazardous
Substances in Electrical and Electronic Products" and "Marking for the Restricted Use of Hazardous Substances in
Electronic and Electrical Products" (SJ/T 11364-2014), which were promulgated on January 26, 2016. The
number displayed in the center of the mark indicates the environment-friendly use period (number of years) in
which electrical and electronic products that are being produced, sold, or imported to China can be used. The date
of manufacture of the electrical and electronic product is the starting date of the environment-friendly use period
for the product. The six specified hazardous substances contained in the product will not leak outside of the
product during normal use within this period and will have no serious impact on the environment, the human
body, or property.
The environment-friendly use period for this product is 15 years. This period is not the product warranty period.
Parts Name
Lead (Pb)
Circuit Board
Electronic Parts
Brass Screw
Aluminum Die Casting
This table has been prepared in accordance with the provisions outlined in SJ/T 11364.
○: Indicates that said hazardous substance contained in all of the homogeneous materials for this part is below or equal to the limit requirement of GB/T 26572.
×: Indicates that said hazardous substance contained in at least one of the homogeneous materials used for this part is above the limit requirement of GB/T 26572.
Note:
This product complies with EU RoHS directives. In this table, "×" indicates that hazardous substances that are exempt from EU RoHS directives are contained.
130
Sets the drive operation when the PTC input signal to the drive is at the oH4 [Motor Overheat
Fault (PTC Input)] detection level.
Figure 6.7 China RoHS Mark
Table 6.5 Contents of Hazardous Substances in This Product
Mercury (Hg)
× ○
× ○
× ○
× ○
Description
Hazardous Substances
Hexavalent
Cadmium (Cd)
Chromium (Cr(VI))
○ ○
○ ○
○ ○
○ ○
TOMPYEUOQ2A03C AC Drive Q2A Installation and Operation Instructions
Default
(Range)
1
(0 - 2)
Polybrominated
Polybrominated
Diphenyl Ethers
Biphenyls (PBB)
(PBDE)
○ ○
○ ○
○ ○
○ ○