Symbols; Abbreviations; General Information - aldes T.Flow Hygro+ Instrucción De Instalación

• Should the motor overheat, a manual reset thermostat will automatically stop the fan. Switch off the power supply (circuit
breaker on electrical switchboard), check that nothing is hindering the operation of group CMEV (for example, blocking,
rubbing, fouling of the impeller, abnormal noise, etc.) and wait for one hour before switching back on. To prevent any danger
caused by the untimely reset of the thermal circuit breaker, this device should not be connected to an external switch such
as a timer or to a circuit that is regularly powered on or off by the electricity supplier. This warning relates solely to the L and
N terminals and not terminals 4 and 5, dedicated to the dual tariff.
• If the problem persists, contact your installer or vendor.
• Only use genuine spare parts supplied by the manufacturer.
• The equipment must not be modified in any way to avoid invalidating the warranty.
• Service the equipment regularly to ensure its smooth operation.
• To drain the water heater:
1. Disconnect the power supply to the tank,
2. Close the shut-off valve on the cold water inlet and/or the general water supply,
3. Turn on at least one tap (kitchen or bathroom),
4. Open the safety valve on the unit and check the draining of the water heater through the safety group.
Watch out for risks of burns when draining the hot water.

1.2. Symbols

Hazard or important information. Risk of personal injuries and damage to property.
Do not fail to comply with the instructions for the safety of people and property.
Reference to pages. Refers to other guides or other pages in the guide.

1.3. Abbreviations

• DHW: domestic hot water

1.4. General information

Thank you for choosing an ALDES product. We recommend that you read this document carefully and follow the instructions
provided to ensure optimal operation of your equipment.
Our liability as a manufacturer shall not be affected due to incorrect use of the equipment, lack of or unsuitable servicing or
incorrect installation. To ensure continuous improvement in the quality of our products, ALDES reserves the right to amend
any product details published in this document at any time.
The smooth operation of the equipment is dictated by strict compliance with this guide.
Failure to comply with these stipulations could invalidate the warranty.
• CMEV: centralised mechanical extract ventilation
39
• T°C: temperature
EN