EN
Detach the pressure regulator from the lid and pull off the old rolling diaphragm.
Place the new rolling diaphragm on the plastic pin of the cooking indicator and press the
rim onto the metal piston until the thread starts.
Cooking valve seal (Fig. A-18)
See Figure W
Detach the pressure regulator from the lid and pull off the old seal. Set the pressure
regulator to setting 3, as it is easier to insert the seal in this position.
First place the new seal over the metal piston and then press the other side over the valve
tappet until it is completely submerged at the top. Make sure that the cooking valve seal
is tight against the pressure regulator all the way around and that the seal is seated in the
notch provided.
Valve seat seal (Fig. A-19)
See Figure X
Remove the pressure regulator from the lid and pull off the old seal.
Insert the new gasket and make sure that the gasket is clean and flat on both sides of the
lid.
O-ring for the Euromatic (Fig. A-21)
See Figure I
Disassembly/assembly takes place on the inside of the lid. Make sure that the seal lies
completely in the groove provided for it.
Euromatic (Fig. A-21)
To disassemble/assemble the Euromatic, you must first remove the lid handle. To do this,
you only need to loosen the screw on the inside of the lid. Once you have removed the
O-ring, you can remove the Euromatic from the lid. To assemble, guide the new Euromatic
without O-ring through the lid so that the side with the white ball is on the inside of the lid.
Then fit the O-ring as described above.
Spare parts
Spare part ..........................................................Diameter .......... Item number
Sealing ring (Fig. Y-1) ......................................................... 18 cm ................... 600-000-18-795
................................................................................................ 22 cm ................... 600-000-22-795
................................................................................................ 26 cm ................... 600-000-26-795
Pot handle for pressure skillet (Fig. Y-2) ......................... 18 cm ................... 620-100-01-850
................................................................................................ 22 cm ................... 620-300-02-850
................................................................................................ 26 cm ................... 620-700-04-850
Pot handle for pressure cooker (Fig. Y-2) ....................... 18 cm ................... 620-100-02-850
................................................................................................ 22 cm ................... 620-300-04-850
................................................................................................ 26 cm ................... 620-700-08-850
Helper handle for pressure skillet (Fig. Y-3) ................... 18 cm ................... 610-110-01-840
................................................................................................ 22 cm ................... 610-310-02-840
................................................................................................ 26 cm ................... 610-710-04-840
40
Helper handle for pressure cooker (Fig. Y-3) ................. 18 cm ................... 610-110-02-840
................................................................................................ 22 cm ................... 610-310-04-840
................................................................................................ 26 cm ................... 610-710-08-840
Lid handle (Fig. Y-4) ............................................................ all ........................... 620-000-11-770
Pressure regulator (Fig. Y-5) ............................................. all ........................... 610-010-00-700
Bell nut for pressure regulator (Fig. Y-6)......................... all ........................... 610-000-00-734
Rolling diaphragm (Fig. Y-7) ............................................. all ........................... 610-000-00-711
Cooking valve seal (Fig. Y-8) ............................................. all ........................... 610-000-00-706
Valve seat seal (Fig. Y-9) .................................................... all ........................... 610-000-00-733
Set of rolling diaphragm, cooking valve seal,
valve seat seal(Fig. Y-7, Y-8, Y-9) ..................................... all ........................... 610-000-01-706
Complete Euromatic (Fig. Y-10) ....................................... all ........................... 011-631-00-750
O-ring for Euromatic (Fig. Y-11) ....................................... all ........................... 011-631-00-760
Fastening screw for the lid handle
with flat gasket (Fig. Y-12)................................................. all ........................... 600-000-00-712
Accessories
Accessory part ...................................................Diameter .......... Item number
Perforated insert (incl. tripod) (Fig. Z-1) ......................... 18 cm ................... 610-100-00-800
................................................................................................ 22 cm ................... 610-300-00-800
................................................................................................ 26 cm ................... 610-700-00-800
Unperforated insert (incl. tripod) (Fig. Z-2) .................... 22 cm ................... 610-300-00-820
................................................................................................ 26 cm ................... 610-700-00-820
Additional glass lid (Fig. Z-3) ............................................ 22 cm ................... 021-641-22-600
Additional metal lid (Fig. Z-4) ........................................... 22 cm ................... 623-000-22-700
................................................................................................ 26 cm ................... 623-000-26-700
All Fissler original spare parts can be purchased from Fissler's leading retailers. Our
customer service is also happy to help you (see chapter 10).
You can find a list of dealers and further information at www.fissler.com.
10. Warranty & service
All Fissler products are carefully made from high-quality materials. The quality of
our products is checked several times prior to completion and is subject to a strict
final inspection. We therefore provide a warranty for the following Fissler products in
accordance with the following warranty conditions from the date of purchase, regardless
of the country in which you purchased this Fissler product. We thus guarantee that these
Fissler products are free from material or processing defects. In addition to the warranty,
you are entitled to the statutory warranty rights, which are not restricted by this warranty.
EN
DE
EN
FR
ES
IT
NL
RU
GR
TR
KO
ZH
JA
PL
CZ
SR
HR
HU
SK
SL
RO
BL
AR
41