Troubleshooting; Technical Support; Disposal Of The Appliance - Royal Catering RC-711 MB Manual De Usuario E Instrucciones De Funcionamiento

4. TROUBLESHOOTING

Type of fault
Control panel warning
lights totally off
(The oven does not work)
Cooking cycle set: the oven
does not work
Automatic humidifier
active: no humidity/steam
production in the cooking
chamber
Closed door: steam escapes
through the gasket
The oven does not cook
evenly
Lamp (LED) in the cooking
chamber does not work
The thermal safety device is
activated continuously

5. TECHNICAL SUPPORT

Before leaving the factory this appliance has been calibrated and tested by experienced and skilled
personnel in order to obtain the best operating results. Any repair or calib ration must be carried
out with the utmost care and attention, using only original parts.
That is why it is required to always contact the Dealer who has sold the appliance or our nearest
Technical Support Centre, specifying the kind of failure and the mod el of the appliance you have.
The parts required for adaptation to different types of gas are provided with the appliance hence
supplied upon sale or delivery.

6. DISPOSAL OF THE APPLIANCE

In accordance with Directive 2012/19/EU on the disposal of wast e electrical and
electronic equipment, the crossed-out wheeled bin symbol on the equipment
indicates that the product was placed on the market after 13 August 2015, and
that at the end of its services life it must be disposed of separately from other
waste.
At the end of the appliance's service life, the user must, therefore, deliver it to
the appropriate centres (recycling centres) for the separate collection of
electrical and electronic waste.
All appliances are made of recyclable metal materials (stainless steel, galvanised
sheet metal, iron, copper, aluminium, etc.) which make up more than 90% of
the total weight of the appliance. Before disposing of the appliance, it is
recommended to make it unusable by removing the power supply cable and removing the
mechanism for closing compartments and/or openings, if any.
The separate waste collection and subsequent treatment, recovery and disposal, are conducive to
the production of equipment with recycled materials and reduce the negative effects on the
environment and health possibly caused by incorrect waste handling. Illegal disposal of the product
by the user entails the application of administrative penalties.
7
Cause of the fault
- Non-compliant connection to the power
mains
- No mains voltage
- Safety thermal device triggered
- Door open or ajar
- Door sensor damaged
- Non-compliant water mains connection
- Closed stopcock
- Obstructed water inlet filter
- Damaged water inlet solenoid valve
- Non-compliant gasket assembly
- Damaged gasket
- Handle "nose" adjusted incorrectly
- One of the motors is down or operates at
low speed
- The motors do not reverse direction
- Resistor not powered or damaged
- Lamp (LED) damaged
- Damaged device
- Control thermostat damaged
Corrective action
- Check the connection to the mains
- Restore the power supply voltage
- Restore the safety thermal device
- Close the door properly
- Contact a skilled technician
- Check the connection to the water
mains
- Check the cock
- Clean the filter
- Contact a skilled technician
- Check gasket assembly
- Contact a skilled technician
- Contact a skilled technician
- Contact a skilled technician
- Contact a skilled technician
- Contact a skilled technician
- Replace the lamp (LED)
- Contact a skilled technician
- Contact a skilled technician