Steam Drain; Maintenance Instructions; Access To The Components For Inspection - Royal Catering RC-711 MB Manual De Usuario E Instrucciones De Funcionamiento

3.12 Steam drain

The appliance is equipped with a special metal pipe (DN30) for the discharge of steam from the cooking
chamber.
No other type of pipe can be connected to this pipe, which protrudes from the back of the casing.
Failure to comply with this specific prohibition shall relieve the Manufacturer from any liability concerning
the potential malfunction of the appliance and poor cooking quality.
Increasing the length of the original drain hose may result in the formation of abnormal "condensation" in
the cooking chamber.
To prevent steam from escaping from the exhaust pipe, place the appliance under the extractor hood, or
connect it to the extractor hood/condensing hood, specific for the appliance model used.

4. MAINTENANCE INSTRUCTIONS

A periodic check (at least once a year) of the appliance contributes to extending its service life and assures
proper operation.
Any maintenance operation on the appliance must only be done by highly qualified personnel trained in
the operations being performed and authorised. Operations must be carried out in accordance with the
safety regulations in force in the country where the appliance is installed, pursuant to the regulations
relative to plants and to workplace safety.
Before carrying out any maintenance on the appliance it must be disconnected from the mains and allowed
to cool down.
The Manufacturer is not responsible for any appliance faults caused by defective maintenance.

4.1 Access to the components for inspection

Removing the left side:
- Magnetic door sensor (door opening to the right)
- Control thermostat bulb (door opening to the left)
- Contactors
- Anti-interference filter (if any)
- Condensation hood control terminal block (if any)
Removing the back;
- Tangential motor (on the back)
- Circular resistors
- Radial motors
- Contactors
- Power supply terminal board
- Safety thermostat
- Capacitors
- Humidification solenoid valve
- Magnetic door sensor control transmission relay
- Cam programmer (Motor reversing gear)
- Humidification piping/fittings unit
Removing the right side:
- Magnetic door sensor (door opening to the left)
- Control thermostat bulb (door opening to the right)
- 12-way electrical wiring connector for controls (on door)
Removing the control protection box (on door):
- Timer ("End of cooking")
- Regulation thermostat
- Automatic humidifier
- Warning lights
Opening the glass inside the door
- Cooking chamber lighting lamp (LED)
8