Quick Guide; Direct Calibration; Direct Measurement; Starting A Method - Mettler Toledo SevenExcellence Instrucciones De Instalación

5 Quick Guide
SevenExcellence™ is delivered with default parameters for calibration and measurement as well as
for methods to ensure an immediate deployment of the instrument after installation.
This quick guide leads you through the first steps of using SevenExcellence™.
For a detailed guidance in using the extensive features of SevenExcellence™ the user is referred to
the operating instructions.
The steps below are a quick guide to start an analysis when the SevenExcellence™ is installed
and modules are attached.
5.1 Direct Calibration
1 Select a suitable sensor for the calibration and connect it to the module (ISM sensors are
detected automatically, tap [Home] and go on with step 4).
2 Tap [Sensors], tap [New], enter Parameters. If an external temperature probe is used, repeat
this step and enter the parameters of the probe.
3 Tap [Save], tap [Home].
4 Tap the colored tag of the module you use for calibration, Module settings is displayed.
5 Tap the list field Sensor name and select the sensor you use, if necessary select the external
temperature probe.
6 Adjust the General settings and Calibration settings if necessary.
7 Immerse the electrode/sensor in the sample, tap [Calibrate].
5.2 Direct Measurement
1 Select a suitable sensor for the measurement and connect it to the module (ISM sensors are
detected automatically, tap [Home] and go on with step 4).
2 Tap [Sensors], tap [New], enter Parameters. If an external temperature probe is used, repeat
this step and enter the parameters of the probe.
3 Tap [Save], tap [Home].
4 Tap the colored tag of the module you use for measurement, Module settings is displayed.
5 Tap the list field Sensor name and select the sensor you use, if necessary select the external
temperature probe.
6 Adjust General settings and Measurement settings if necessary.
7 Tap [Save].
8 Immerse the electrode/sensor in the sample, tap [Read].
5.3 Starting a Method
1 Select a suitable sensor for the method and connect it to the module (ISM sensors are detected
automatically, tap [Home] and go on with step 4).
2 Tap [Sensors], tap [New] enter Parameters. If an external temperature probe is used, repeat
this step and enter the parameters of the probe.
3 Tap [Save], tap [Home].
4 Tap [Methods], select a method or tap [New] to use a Method type template. Use the default
parameters or modify them according to your requirements.
5 Tap [Save].
6 Immerse the electrode/sensor in the sample, tap [Start].

Quick Guide

19