Lavorwash SWL R 1300 Manual De Instrucciones página 53

Figure 21
The LED ceiling light in the cab is switched on or off via the pressure switch shown in Figure 21 .
Above the latter (Figure 21) is the stable position switch (Figure 22), which activates the window washer device .
The device is activated when the switch is pressed and deactivated when it is released .
The windscreen wiper is activated via the two-position stable switch (Figure 23) . In position 1 the windscreen
wiper is activated while in position 0 it is deactivated .
4.4. USE OF SAFETY PROTECTIONS AND DEVICES
4.4.1. WASTE CONTAINER SAFETY BAR POSITIONING
The safety bar (Item 10 Figure 2) prevents accidental closure of the waste container when it is lifted .
After the container has been lifted, remove the safety bar from the rest position (Pos. 1 Figure 24) and place
the safety bar in the base (Pos. 2 and 3, Figure 24) .
Remove the safety bar by lifting it from the base, sliding it along the slot and repositioning it in the initial position .
MAKE SURE THAT THE SAFETY BAR HAS BEEN DISCONNECTED BEFORE LOWERING THE
WASTE CONTAINER.
4.4.2. ENGINE HOOD, SEAT HOOD AND FILTER COVER SAFETY DEVICES
The engine hood (Item 1 Figure 2), the seat hood (Item 3 Figure 2) and filter covers (Item 2 Figure 2) can
be easily opened to allow for inspection and maintenance operations . They are equipped with safety devices that
prevent accidental closure .
In particular, the engine hood and seat hood are equipped with safety rods that fit together as shown in Figure
25 .
Figure 22
Figure 24
53
Figure 23