Lavorwash SWL R 1300 Manual De Instrucciones página 57

CHECK THAT THERE ARE NO PERSONS LESS THAN 2 METERS FROM THE
MOTORSWEEPER DURING THE WASTE CONTAINER EMPTYING OPERATIONS. ALSO
CHECK THAT THERE IS ADEQUATE SPACE TO AVOID SHOCKS THAT COULD DAMAGE THE
MOTORSWEEPER AND COMPROMISE ITS OPERATION (PARAGRAPH 10.3.2).
IMPORTANT: Before starting the work, check if on the surface there are any cords,
plastic or metal wires or long rags, sticks, power wires etc.; these are dangerous and
could damage the dust seals and brushes. They must therefore be removed before
starting work with the machine.
IMPORTANT: For safety reasons, the machine switches off automatically if the operator
gets up from the driving position. It can only be started when seated in the driver's
seat.
•
Be very careful when passing over rails or gate guides etc . These are the source of the greatest damage
to the dust seals . When it is necessary to pass over them, do so very slowly .
•
Disconnect the filter system when moving the machine over wet or very wet surfaces to avoid
dampening and therefore deteriorating the filter. Avoid passing over puddles.
•
If the surface to be cleaned is very dirty due to the quantity or quality of the material or dust to be
collected, it is advisable to carry out a first "rough" sweep without paying too much attention to the
result obtained. After this, with the waste container empty and the filters well shaken, repeat the steps;
this will obtain the desired effect.
•
The side brush must only be used for cleaning edges, profiles, corners, etc., it must be raised (disconnected)
immediately afterwards in order to avoid raising unnecessary dust, and because the result obtained with
the side brush inserted is always lower than that of the central brush only .
•
For a good result, empty the container often and keep the filters clean by vibrating them by means of
the filter shaker.
8.2. TRAINING OF OPERATORS
There is no need for special training of the operator with regard to the use of the motorsweeper, except for the
information contained in this manual and, in that, relating to the engine .
8.3. OPERATIONAL START-UP
To start the machine:
Turn the starter key (Item 1 Figure 12) into the "ON" position, to the first click (Figure 29) . The electric
motorsweeper services are also activated;
Turn it again to the "GL" position, to the second click, to activate the preheating of the engine spark plugs. The
relative light on the indicator (Item 16 Figure 12) is activated (no. 2 Figure 18) .
Wait for the preheating light to turn off;
Turn the key to the "ST" position, to the third click. The engine begins to start;
When the engine is started, release the key that will return to the "GL" position.
After starting, gradually bring the throttle lever (Item 2 Figure 12) to the end of the stroke, allowing the engine
to warm up for a few minutes .
Adjust the throttle lever to at least ½ ÷ ¾ of the stroke for optimal performance .
Figure 29
57