Control; Range Hood Care - arietta ADI436SSB Guía De Instrucciones Para Instalación

Control

1. Light On/Off button
2. Blower On/Off button
3. Blower speed minimum button
4. Blower speed medium button
5. Blower speed maximum button
NOTE: Control buttons will light up when range hood is On.
Operating the light
The Light On/Off button (1) controls both lights. Press once for
On and again for Off.

Range Hood Care

I
ATTENTION!
Before performing any maintenance operation, isolate the hood
from the electrical supply by switching off at the connector and
removing the connector fuse.
Or if the appliance has been connected through a plug and
socket, then the plug must be removed from the socket.
Cleaning
Do not spray cleaners directly to the control while cleaning the
Hood.The cooker hood should be cleaned regularly (at least
with the same frequency with which you carry out maintenance
of the fat filters) internally and externally. Clean using the cloth
dampened with neutral liquid detergent. Do not use abrasive
products.
DO NOT USE ALCOHOL!
Exterior surfaces:
To avoid damage to the exterior surface, do not use steel wool
or soap-filled scouring pads. Do not use chlorine base cleaners.
Rub in direction of the grain line to avoid scratching the surface.
I
WARNING
Failure to carry out the basic cleaning recommendations of the
cooker hood and replacement of the filters may cause fire risks.
Therefore, we recommend oserving these instructions.
The manufacturer declines all responsibility for any damage to
the motor or any fire damage linked to inappropriate maintenance
or failure to observe the above safety recommendations.
Grease filter
Traps cooking grease particles.
This must be cleaned once a month using non aggressive
detergents, either by hand or in the dishwasher, which must be
set to a low temperature and a short cycle. When washed in a
dishwasher, the grease filter may discolour slightly, but this does
not affect its filtering capacity. To remove the grease filter, pull the
spring release handle.
A. Spring release handle
Operating the blower
The Blower On/Off button (2) turns the blower On or Off.
The Blower Speed buttons (3, 4 and 5) set the desired speed and
control the sound level for quiet operation. The speed can be
changed anytime during fan operation by pressing the desired
blower speed button.
1. To turn the blower On, press the Blower On/Off button (2) and
2. To turn the blower Off, press the Blower On/Off button (2).
Any of the 3 blower speed buttons can be in the On position
at the same time. The blower will operate at the highest speed
button that is pushed in. For lower blower speeds, the higher
speed buttons must not be pushed in.
Replacing a LED Lamp
The LED lights are replaceable by a service technician only. See
"Who to contact" section in the warranty for service contact
information.
Charcoal filter
I
When used in recirculation mode, To Reduce the Risk of Fire and
Shock use only conversion kit Models:
Recirculating kit: KIT02665
Charcoal filter replacement: KIT02667
If the model is not vented to the outside, the air will be
recirculated through disposable charcoal filters that help remove
smoke and odors.
1. Cover the grill that protects the suction motor with the carbon
2. Turn the carbon filter clockwise to block them (bayonet fixing).
NOTE: The charcoal filters cannot be cleaned. It should be
replaced every 4-6 months (depending on hood usage).
NOTE: DO NOT rinse, or put charcoal filters in an automatic
dishwasher.
NOTE: Charcoal filters are not included with the hood. They must
be ordered from your supplier. Order the needed kit specifying
your hood model and width size.
A
11
the desired speed button (3, 4 or 5).
WARNING
filter so that the slots on the filter correspond to the pins on
the sides of the motor protection grill.