Tools And Parts; Parts Not Supplied - arietta ADI436SSB Guía De Instrucciones Para Instalación

Tools and Parts

Parts supplied
Removing the packaging
I
CAUTION!
Remove carton carefully, wear gloves to protect against sharp
edges.
Part
Hood assembly with blower and LED lamps
already installed
5x45 mm
4.2x8 mm
3.5x9.5 mm
3.5x6.5 mm
2.9x3 mm
Leveling screws
8x40 mm
Horizontal supports

Parts not supplied

Tools/Materials required
• Wire nuts
• Tape to mount template
• 6" (15.2 cm) rounded metal duct length to suit installation
• Measuring tape
• Pliers
• Gloves
• Knife
• Safety glasses
• Electric drill with ⁄ " and 3⁄
5
16
• Strain relief
• Spirit level
• Duct tape
Qty
1
4
62
2
4
2
2
4
2
" bits
8
I WARNING!
Remove the protective film covering the product before putting
into operation.
art
Lower and upper duct covers
6" round air transition
Duct cover brackets
Vertical supports
Torx adapter
Mounting template
• Screwdrivers:
- Phillips (Posidrive) #2
- Flat blade
• Wire cutter/stripper
• Masking tape
• Hammer
• Saw, jig saw or reciprocating saw
Parts needed
• Home power supply cable
• ½" (12.7 mm) UL listed or CSA approved strain relief
• 3 UL listed wire connectors
For vented installations, you will also need:
• 1 wall or roof cap
• Metal vent system
3
Qty
Upper: 2
Lower: 2
1
4
Upper: 4
Lower: 4
#10: 1
#20: 1
1