GASPARDO NINA Empleo Y Mantenimiento página 39

3.4.6 ADJUSTMENT OF THE DISTANCE BETWEEN ROWS
The width of the planting unit and the number of the furrow openers
determine the distance between rows. To change the interrow
distance, follow the diagrams shown in the Spare Parts Booklet
according to the type of furrow opener (hoe, single disc, double
disc). To increase or decrease the interrow distance for sowing,
remove or add furrow openers as follows (Fig. 20):
- unscrew the nut (A) and the screws (B).
- Once the desired number of the coulters has been obtained they
must all be set at the same distance (measured at the coulters),
and the screws tightened again.
- Make sure that only the sliding doors of the distributors that have
the telescoping tube (Fig. 21, C) are open; all the others must be
closed.
3.4.7 DISABLING SOWING BY HALF OF THE MACHINE
The transmission to the seed distributors has been equipped with
a mechanical system that allows you to disable operation, and
therefore sowing, by the left side of the equipment (Fig. 22).
Located at the centre of the equipment, the system allows you
to disable the transmission in the left hand section with a simple
manual movement (Fig. 22):
A) equipment operating with all the distributing parts;
B) equipment operating with just the right hand section.
fi g. 22
cod. G19502553
USE AND MAINTENANCE
A
B

A
B
fi g. 20
ENGLISH
C
2119
39