Jøtul F 263 Instrucciones Para Instalación página 13

extreme stress in the chimney. Add fuel to the fi re in moderation.
Avoid smouldering fires as this produces the most pollution.
The fi re is best when it is burning well and the smoke from the
chimney is almost invisible.
Refuelling on to a low fi re bed: If there is insuffi cent
•
burning material in the fi rebed to light a new fuel charge,
excessive smoke emission can occur. Refi lling must be
carried out onto a suffi cient quantity of glowing embers
and ash that new fuel charge will ignite in a reasonable
period. If there are too few embers in the fi re bed, add
suitable kindling to prevent excessive smoke.
Fuel overloading: The maximum amount of fuel specifi ed
•
in this manual should not be exceeded, overloading can
cause exess smoke
Operating with door left open: Operation with the door
•
open can cause excess smoke. This appliance must not
be operated with the appliance door left open except as
directed in the instructions.
Dampers left open: Operation with the air controls or
•
apploance dampers can excess smoke. The appliance
must not be operated with air controls, appliance dampers
or door left open exept as directed in the instructions.
5.2 Danger of overheating
The fi replace must never be used in a manner that
causes overheating
Overheating occurs when there is too much fuel and/or too much
air so that too much heat develops. A sure sign of overheating is
when parts of the fi replace glow red. If this happens, reduce the
air vent opening immediately.
Seek professional advice if you suspect that the chimney is not
drawing properly (too much/too little draught). For further
information, see «4.0 Installation» (Chimney and fl ue pipe).
5.3 Ash removal
The product have an ash pan which makes it easy to remove
the ash.
Use the fi replace set (Fig. 24).
Warning: The fi replace set can get hot.
Fig. 27
A
1. Scrape the ash through the grate (Fig. 27 A) in the base plate
and into the ash pan. Use a glove to grab the handle on the
ash pan.
2. Make sure that the ash pan doesn't fi ll up so high that it keeps
ash from coming through the grate into the pan.
6.0 Service
Warning! Any unauthorised change to the product is not allowed.
Only use original spare parts.
All service must be done when the stove is cold!
6.1 Changing the burn plates/inner
bottom plate
Fig.28
B
D
A
C
ENGLISH
13