GASPARDO NINA Empleo Y Mantenimiento página 42

ENGLISH
3.6 REAR COVERING HARROW
The normal working position of the harrow is shown in Figure 25.
In this position, the wear on the teeth, between the long and the
short one is even and uniform. By adjusting the regulating handle
(A), it is possible to change the angle of the harrow.
The working pressure of the spring-loaded teeth can be varied
by rotating the spring (B) located on the upper parallel arm (Fig.
26).
3.7 SEED LEVEL IN THE HOPPER
The level of seed in the hopper can be easily controlled by the
operator from the driver's seat by checking the indicator (Fig. 27).
42
USE AND MAINTENANCE
fig. 25
fig. 26
fig. 27
g
A
B
cod. G19502550