GYS POT COMBI ARCPULL Manual De Instrucciones página 24

Operating manual
WARNINGS - SAFETY INSTRUCTIONS
GENERAL INSTRUCTIONS
These instructions must be read and fully understood before use.
Do not carry out any alterations or maintenance work that is not directly specified in this manual.
The manufacturer shall not be liable for any damage to persons or property resulting from use not in accordance with
the instructions in this manual.
In the event of a problem or uncertainties, please consult a qualified person to handle the installation properly..
ENVIRONMENT
This equipment should only be used for welding operations performed within the limits indicated on the information
panel and/or in this manual. These safety guidelines must be observed. In the event of improper or dangerous use, the
manufacturer cannot be held responsible.
The machine must be used in an environment free of dust, acid, flammable gases or any other corrosive substances.
Operate the machine in an open, or well-ventilated area.
Temperature range:
Use between -10 and +40°C (+14 and +104°F).
Store between -20 and +55°C (-4 and 131°F).
Air humidity:
Lower than or equal to 50% at 40°C (104 °F).
Lower or equal to 90% at 20°C (68 °F).
Altitude :
Up to 1,000m above sea level (3280 feet).
INDIVIDUAL PROTECTIONS AND OTHERS
Arc welding can be dangerous and cause serious injury or death. The machine is intended to be operated by qualified
personnel who have received appropriate training in the use of the machine (eg: panel beater training).
Welding exposes people to dangerous heat, light radiation from the arc, electromagnetic fields (beware if you have a
pacemaker), risk of electrocution, noise, and gas emissions.
To protect yourself and others, please comply with the following safety instructions:
To protect yourself from burns and radiation, wear clothes without cuffs/lapels, that are insulating, dry,
fireproof and in good condition, and that cover the whole body.
Wear protective gloves which provide electrical and thermal insulation.
Use welding protection and/or a welding helmet with a sufficient level of protection (depending on the
specific use). Protect your eyes during cleaning procedures. Contact lenses are specifically forbidden. It
may be necessary to enclose the welding area with fireproof curtains in order to protect the work area
from arc radiation, welding spatter, and other high-temperature waste .
Inform people in the welding area not to stare at the arc rays or molten parts and to wear appropriate
clothing for protection.
Wear noise protection headphones if the welding process becomes louder than the permissible limit (this
is also applicable to anyone else in the welding area).
Keep hands away from moving parts (fan), hair, clothing.
Never remove the covers of the cooling unit when the welding power source is on, the manufacturer
cannot be held responsible in the event of an accident.
Newly welded parts are hot and can cause burns when handled. When servicing the gun or electrode
holder, Make sure that it is sufficiently cool by waiting at least 10 minutes before any manipulation. It is
important to secure the working area before leaving it, in order to protect people and property.
24
Original manual
GYSPOT COMBI ARCPULL