GYS POT COMBI ARCPULL Manual De Instrucciones página 40

Operating manual
START-UP AND SETTINGS
1. Connect the gun (or guns) with the connectors.
The trigger gun has, in addition to the power connector, a connector for the control
trigger. Connect the latter to initiate using the trigger.
2. To switch the machine on, turn the knob (2) to the right (FIG-I p.2).
3. On first use:
• The displays and indicator lights illuminate briefly and then the unit automatically enters SYNERGIC mode (12)
(FIG-II p.2). It indicates:
- the tool (1): set to 1 by default (star welding/slide hammer or Manuliner).
- the power level (2): set to 2 by default (suitable for 0.8 mm steel sheet).
• To use the MANUAL mode (10), press key (8).
The SYNERGIC mode give to the user recommended factory settings for each tool used on a given sheet thick-
ness.
he MANUAL mode allows the user to choose their own settings without the tool connected being taken into
account, by selecting the desired power and spot time.
4. Depending on the mode chosen, SYNERGIC or MANUAL, change the settings as follows:
- To change the tool, press the arrows (13) - (Available in SYNERGIC mode only).
1 Dent removal work using the inertia ham-
mer, stars, or dent pulling clamp.
2 Welding rings for straightening work.
3 Impact shrinking with a specific copper tip.
4 Carbon electrode for retensioning.
- To change the power level, press the arrows (9).
The power levels available allow the straightening of sheets of varying thickness.
40
Original manual
5 Welding of rivets for sideway rods.
6 Welding wavy wires or washers for earth
attachments.
7 Welding studs for vehicle weights and
linkages
GYSPOT COMBI ARCPULL