GYS POT COMBI ARCPULL Manual De Instrucciones página 32

Operating manual
From the synergy displayed on the screen, defined by a part type (3), its material (1) and its protection (2), it is only
possible to change the size of the part (M4, M5, etc.) by pressing G+ and G- without having to go through
the settings menu.
Insert Pictograms
Pull ring
Stud
Insulation nail
THICKNESS OF THE SUPPORT PLATE
Thickness displayed in millimetres.
To increase or decrease the thickness of the sheet on which the insert will be welded, press the D+ and D- keys. The
thickness ranges that can be selected are dependent on the type, size, and material of the part to be welded.
If the thickness of the sheet metal is less than that shown on the display, the sheet may become deformed
at the weld. When the display shows
are no longer affected.
If this symbol does not appear, then the maximum sheet metal thickness has been reached. Over this thickness, the
welding of the insert is no longer guaranteed.
Note : When switching from Synergic to Manual mode, all welding parameters (current, time, height, etc.) associated
with that synergy are transferred to manual mode. This makes it possible to fine-tune the machine settings if the selec-
ted synergy does not achieve the expected result (welding with too much, or not enough, energy).
WELDING IN MANUAL MODE
In Manual Mode the time, current, the lift height for the insert and the activation of the digital spring are user-defined.
The main screen of Manual Mode displays:
1 — Arc time in milliseconds
2 — Arc current
3 — A message field specifying the status of the product
32
Original manual
1
Alspec
Ar
2
n°4
3
1.5mm
Comments
Pressing the G+ and G- keys will
scroll through all the ring synergies
contained in the unit. The material (1)
and gas protection (2) are updated
automatically.
M6
Synergies associated with studs
, the sheet thickness is sufficient and the welding parameters of the synergy
t
ms
1
100
3.0
4
zone de
message
message
area
5
Photo
I
A
2
200
message
area
3
GYSPOT COMBI ARCPULL