GYS POT COMBI ARCPULL Manual De Instrucciones página 36

Operating manual
Reset machine
Product reset
:3sec
to reset
Information panel
Info
Soft gene V3.0
Hard gene V1.0
Gun 200-350
Soft gun V3.0
Hard gun V7.0
UPDATE VIA USB
In order to benefit from new synergies and software improvements, it is possible to update the aluminium side via the
USB socket on the front. To do so, contact the GYS service department and follow their instructions.
TOOLS FOR THE GUN
Optional, welding inserts on aluminium/steel is also possible with the accessories listed at the end
of the manual (studs, insulation nail...).
CHANGE THE GUN EARTH RODS
Loosen the locking knob so that the ground rods
extend as far as possible from the gun.
Then tighten the locking knob.
Unscrew the two cover screws and release the
cover towards the front of the gun.
Slightly unscrew the two screws used to hold the
rods.
If replacing the rod, remove the rods by pulling on
them, then put a new one in.
36
Original manual
When the "Reset Machine" option is selected from the Configuration menu, pressing
menu/enter opens the reset machine sub-menu.
Press menu/enter for 3 seconds to confirm product reset.
Push the return button
the unit.
Resetting the Alu side of the unit switches the product back to French, and the pre-gas
and post-gas are reset to 0.4s.
The information panel shows the software and
hardware version numbers of the power source
and gun.
to return to the Configuration menu and cancel resetting
GYSPOT COMBI ARCPULL