GYS POT COMBI ARCPULL Manual De Instrucciones página 28

Operating manual
SETTING UP THE EQUIPMENT
• Place the welding power source on a floor with a maximum inclination of 10°.
• Provide sufficient space to ventilate the welding power source and access the controls.
• Do not use in an area with conductive metal dust.
• Power cables, extension cables and welding cables should be fully unwound to avoid overheating.
• The manufacturer assumes no responsibility for damage to persons or objects caused by improper and dangerous use
of this equipment.
• The welding power source should be protected from heavy rain and not exposed to direct sunlight.
• The equipment has an IP21 protection rating, meaning:
- the dangerous parts of the machine are protected against entry by objects greater than 12.5 mm and,
- Protection against vertically falling drops of water
• Power cables, extension cables and welding cables should be fully unwound to avoid overheating.
The manufacturer assumes no responsibility for damage to persons or objects caused by improper and
dangerous use of this equipment.
MAINTENANCE/RECOMMENDATIONS
• Anyone using this machine needs to have received appropriate training in the use of the device, in order to
get the most out of its performance, and to carry out the work in accordance with the instructions (e.g: panel
beater training).
• Check which welding process is authorised by the manufacturer before attempting any vehicle repair.
• The maintenance and the repair of the . Any work undertaken by a third party on the machine will invalidate
the warranty. The manufacturer will not accept liability in the event of an incident that would occur after this
work was undertaken.
• Switch off the power supply by pulling out the plug, and wait two minutes before working on the equipment.
Inside, the voltages and currents are high and dangerous.
• All the welding tools will wear off with use. Ensure that these tools are clean to get the best results.
• Before using the gun, check the condition of the different components (star, single-point electrode, carbon
electrode, ...) and then clean or replace them if they are in poor condition.
• On a regular basis, remove the cover and blow out any dust. Take advantage of the opportunity to have the
electrical connections checked with an insulated tool by a qualified professional.
• Regularly review the condition of the power cable and welding connection cables. If there are signs of
damage, they should be replaced by the manufacturer, its customer service department, or a similarly qualified
person, to avoid any danger.
• Leave the welding power source vents free for air intake and outflow.
INSTALLATION – PRODUCT OPERATION
EQUIPMENT DESCRIPTION (FIG-1)
Next generation 2-in-1 dent puller. The Gyspot Combi ARCPULL is used to remove dents from steel
and aluminium bodies. This method of repair by pulling without disassembly is both time-saving and cost-effective.
This machine combines 2 different dent-pullers, with 2 different control panels:
A steel dent remover
with power source, manual gun and ground cable
- The trigger gun is plugged into connector no. 6 and the
control cable into connector no. 5
- The triggerless gun (optional) plugs into connector no. 7
- The ground cable is fixed in position no. 4
28
Original manual
An aluminium dent remover
WITH DRAWN ARC WELDING, the linear motor gun with
integrated quick ground (2 flexible studs)
- The gun is plugged into connector no. 8 and no. 9
- The gun control cable plugs into connector no. 10
- The gas hose connects to no. 13
GYSPOT COMBI ARCPULL