Descargar Imprimir esta página

Kärcher HDS 9/16-4 ST Gas Manual Del Usuario página 28

Ocultar thumbs Ver también para HDS 9/16-4 ST Gas:

Publicidad

Idiomas disponibles
  • ES

Idiomas disponibles

  • ESPAÑOL, página 103
Dirt
Nozzle
Spray an-
gle
strong
0075
medium
2575
25°
light
4075
40°
HDS 12/14
strong
0010
medium
2510
25°
light
4010
40°
Detergent dosing
– Detergents simplify the cleaning task. They are sucked in
from an external detergent tank.
– The basic model of the appliance is equipped with a dosing
valve (C). A second dosing device (dosing valve D) can also
be procured as special accessory. It is then possible to use
two different detergents.
– The dosing quantity is set at the detergent dosing valves (C
or D) at the operating panel. The set value corresponds to
the percentage share of the detergent.
Figure 6
– The outer scale is applicable while using undiluted deter-
gents (100% CHEM).
– The inner scale is appliance while using 1 +3 pre-diluted de-
tergents (25 % CHEM + 75 % water).
The following table gives the detergent consumption for the val-
ues on the outer scale:
Position
Detergent quantity [l/h]
Detergent concentration [%]
The exact dosing depends on:
– Viscosity of the detergent
– Suction height
– Flow resistance of the high pressure pipe
If an exact dosing is required, then measure hte detergent quan-
tity that is sucked in (for e.g. by sucking in from a measurement
beaker).
Note
For list of recommended detergents refer the chapter "Accesso-
ries".
28
English
Part no.
Pressure
6.415
[MPa]
HDS 9/16
-419
10
-421
-422
-082
10
-252
-253
0,5
1
14...15 22...24 50
1,5
2,5
Recoil [N]
Warning
There can be calcium deposits in the continuous heater if you
37
use the appliance without softeners.
If the softener tank is empty, the indicator lamp for protection
against calcification (H) begins to glow.
Figure 1 - Pos. 9
46
Refill the softener tank with softener liquid (RM 110 (2.780-
001).
Danger
Danger of scalding by hot water. After the operation with hot wa-
ter or steam, the device must be operated with openend gun with
cold water for at least two minutes.
If operating with hot water, set the thermostat (B) to the low-
est temperature.
Use the appliance for at least 30 seconds without detergent.
Turn the appliance switch (A) to "0".
Shut off water supply.
Activate hand spray gun until device is pressure-less.
Secure the hand spray gun using the safety catch so that it
doesn't open accidentally.
If the machine is not to be used for a longer period or if it is not
possible to save it in a frost-free environment, then you must take
the following measures (see chapter "Maintenance and care"):
Drain water.
Flush device with anti-freeze agent.
Switch off the main switch and secure it.
Close the gas inlet.
8
> 5
Refilling the softener
Shutting down
After operation with detergent
Turn off the appliance.
Shutdown

Publicidad

loading

Este manual también es adecuado para:

Hds 9/16-4 st gas lpgHds 12/14-4 st gasHds 12/14-4 st gas lpg