Descargar Imprimir esta página

RIDGID SeekTech SR-60 Manual De Instrucciones página 13

Ocultar thumbs Ver también para SeekTech SR-60:

Publicidad

Frequency / Left Key – Used to set the In-Use
Frequency of the SR-60 from the set of Checked-
Active frequencies. Each short press cycles to the next
Checked-Active frequency. (The list of frequencies that
have been set to Checked-Active status can be modi-
fied via the Menu Key.)
A long press on the Frequency Key
lable list of all currently active frequencies to choose
from, by highlighting and pressing Select again.
Figure 8: Scrollable List of Frequencies
Light Sensor – In Automatic mode, the light sensor
controls when the backlight goes on or off depending
on ambient light. Placing a thumb over the light sensor
will force the backlight on.
Operation Time
Using alkaline cells, typical operation time is from about 12 to 24
hours depending on sound volume and how often the backlight
is on. Other factors that affect the operation time will include
chemistry of the battery (many of the new high performance
batteries, such as the "Duracell
than conventional alkaline cells under high demand applica-
tions). Operation at lower temperatures will also reduce battery
life.
The SR-60 display can also show random symbols when the bat-
tery power is too low to drive the internal logic circuits correctly.
This is remedied by simply putting fresh batteries into the unit.
To preserve battery life, the SR-60 will automatically shut down
after 1 hour of no key presses. Simply power the unit on to
resume use.
will display a scrol-
ULTRA" last 10%-20% longer
®
Ridge Tool Company
SeekTech SR-60
Low Battery Warning
When the battery gets low, a battery icon will periodically ap-
pear in the map area on the screen. This indicates that the batter-
ies need to be changed and that the unit will soon shut down. A
tone will sound at ten-minute intervals.
Figure 9: Low-Battery Warning
Just before complete shut down there will be a non-interruptible
power down sequence. An extended buzz will sound when the
SR-60 is about to go into shutdown sequence.
Note: Voltage on rechargeable batteries may sometimes
drop so quickly that the unit will just shut down. The unit will
power down and restart. Just replace the batteries and power
the unit back on.
Starting Up
After pressing the Power Key
displays, and the software version number will appear in the
lower right corner of the screen.
Figure 10: Start-up Screen
Make a note of the software version in the box on page 1.
If technical support from Ridge is needed, it will be helpful to
have it available.
on the keypad, the RIDGID logo
11

Publicidad

loading