Publicidad
Introduction to the SR-60
Getting Started
Installing/Changing Batteries
To install batteries into the SR-60, turn the unit over to access the
battery compartment. Turn the knob on the battery cover coun-
ter clockwise. Pull straight up on the knob to remove the cover.
Insert the batteries as shown on the inside decal and make sure
they drop to full contact. Fit the cover into the case and turn the
knob clockwise while lightly pressing down to close. The battery
cover can be installed in either orientation.
Figure 2: Battery Case
When the SR-60 is powered on, it takes a few seconds to check
the batteries. Until then the battery level will show as "empty".
CAUTION
Do not allow debris or moisture into battery compart-
ment. Debris or moisture may short the battery con-
tacts, leading to rapid discharge of the batteries, which
could result in electrolyte leakage or risk of fire.
Folding Mast
To begin operation, unfold the antenna mast and lock the fold-
ing joint into place. When locating is complete, press the red re-
lease lever to fold the antenna mast for storage.
IMPORTANT!
Do not snap or whip the SR-60 mast to open or close it.
Open it and close it by hand only.
Note: Avoid dragging the lower antenna node on the
ground while locating with the SR-60. It may cause signal
noise which will interfere with results, and may eventually
damage the antenna.
Release Button
Figure 3: Folding Antenna Mast and Release Button
SR-60 Modes
The SR-60 operates in three distinct modes. They are:
1.
Active Line Trace Mode,
can be put onto a long conductor using a Line Transmitter,
for locating conductive pipes, lines, or cables.
2.
Passive Trace Mode,
already carrying 60 Hz current (U.S.), 50 Hz current (Europe),
or radio frequencies.
3.
Sonde Mode,
or tunnels that are non-conductive or cannot otherwise be
traced.
Note that the two Tracing modes, Active and Passive, are iden-
tical except for the frequencies used. No transmitter is used in
Passive Trace mode.
Display Elements
Beginning operators or experienced operators can use the SR-60
with equal ease. While the SR-60 offers advanced features that
make the most complex locate easier, many of its features can
be turned off or hidden, making the SR- 60 simple to use in basic
locating in uncomplicated situations.
The "basic features" of the SR-60 are on by default. They can be
customized easily to suit the user's requirements. The use of the
various elements displayed is covered in later sections of this
manual.
Ridge Tool Company
SeekTech SR-60
used when a chosen frequency
used for tracing electrical lines that are
used for locating Sondes in pipes, conduits,
7
Publicidad
