SWM SIX6 500 Manual De Instrucciones página 24

SIX DAYS
GEAR SHIFT CONTROL
The lever (1) is placed on the left-hand side of the
engine. The operator must release the lever after
each gear change to allow it to return to its central
position. Neutral position (N) is between the first and
second gears.
First gear is engaged by pushing the lever down-
wards; the other gears are engaged in a sequence
by pushing the lever upwards.
The position of the gear shift lever on the shaft can
be varied as follows: loosen the screw, pull the lever
out, and place the lever in a new position on the
shaft.
Tighten the screw once operation is completed.
CAUTION
a a
Do not shift gears without disengaging
the clutch and closing the throttle. The
engine could be damaged by overspeed.
a
WARNING
Do not downshift when travelling at a
speed that would force the engine to
overrev in the next lower gear, or cause
the rear wheel to lose grip.
24 -
EN
FUEL
Recommended fuel: premium grade UNLEADED fuel
(R.O.N. 95).
a
1
Proceed as follows:
- Turn off the engine.
- Move the lock cover (1) to the side.
- Insert the key (2) and turn it by 1/4 of a turn in the
direction of "A" arrow to release the cap (3).
- Turn the cap (3) anticlockwise and remove it from
the tank.
- Refuel through the filler neck (4).
a a
WARNING
Fuel is extremely flammable and can be
explosive under certain conditions.
Always stop the engine and do not
smoke or allow flames or sparks in the
area where the motorcycle is refuelled
or fuel is stored.
CAUTION
Do not fill the tank beyond the lower
limit of the filler neck.