SWM SIX6 500 Manual De Instrucciones página 48

SIX DAYS
REMOVING THE FRONT WHEEL
Position the motorcycle in such a way that the front
wheel is lifted from the ground.
- Loosen the bolts (1) holding the wheel axle (2) to
the front fork mounts.
- Unscrew the pin (2) and remove it.
- Remove the wheel being careful with the ABS
sensor support (3).
Note
Do not operate the front brake lever when the wheel
has been removed; this causes the caliper pistons to
move outwards. After removal, lay down the wheel
with brake disc on top.
48 -
EN
REFITTING THE FRONT WHEEL
- Position the wheel between the legs, fit the ABS
sensor support (1) so that it correctly fits into
place with the fork pin (2), then fit the brake disc
in the calliper checking that it correctly fits into
place.
- Fit the previously greased wheel pin (3) from the
right-hand side and screw it into place (50 N.m).
- Now, pump for a while, pushing the handlebar
downwards until you are sure that the fork legs
are perfectly aligned.
- Lock: the screws (4) on the R.H. leg (10.4N.m).
Note
After refitting the wheel, operate the brake control
lever until the pads touch the disc.