Publicidad
Idiomas disponibles
Idiomas disponibles
Keep the appliance at peak effi ciency by car-
rying out the scheduled servicing procedures
recommended by the manufacturer. Proper ser-
vicing will allow the best performance, a longer
working life and constant maintenance of safety
requirements.
Important
Before carrying out any servicing procedure,
activate all the safety devices provided and
decide whether staff at work and those in the
vicinity should be informed.
In particular, turn off the water supply tap, cut
off the steam supply and prevent access to all
devices that might cause unexpected health
and safety hazards if turned on.
Also make sure that during the maintenance
procedure, that the operator is always able to
check whether the plug is disconnected from
the power outlet.
Since the appliance is used for preparing foods
for human consumption, special care must be
paid to everything relating to hygiene, and the
appliance and the entire surrounding environ-
ment must constantly be kept clean.
Important
GB
Before starting any cleaning procedure, dis-
connect the electricity supply using the circuit-
breaker and allow the appliance to cool.
The precautions which follow are also important.
Caution - Warning
When using detergents, rubber gloves,
protective mask and safety goggles must be
worn in accordance with the relevant safety
regulations.
– Clean all parts of the appliance with warm
water, food-approved detergents and non-
abrasive materials only.
– Thoroughly clean all parts which come into
direct or indirect contact with foods and all
surrounding areas.
3320140_ut_GB_rev.1
SERVICING
INSTRUCTIONS AND WARNINGS FOR SERVICING
CLEANING INSTRUCTIONS
At the end of each session of use and whenev-
er necessary, clean:
– The drain tap ( see page 13).
– The outer casing.
– The well (see page 12).
– The accessories.
– The appliance and the surrounding environ-
ment (see page 12).
Every 100 working hours have skilled, author-
ised personnel carry out the following opera-
tions:
– Check that the electrical system is in good
working order.
– Check that the safety thermostat is working
correctly.
– After use, clean the accessories with a
suitablegrease-remover product. If possible,
wash in the dishwasher.
Caution - Warning
Never use products containing substances
harmful or hazardous for health (solvents,
petroleum spirits, etc.).
– Rinse surfaces with drinking water and dry.
– Pressurised water jets may only be used on
external parts.
– Take special care not to damage stainless
steel surfaces. In particular, avoid the use of
corrosive products and do not use abrasive
materials or sharp tools.
– Remove food residues immediately before
they set.
– Remove the limescale deposits which may
form on some of the appliance's surfaces.
- 12 -
ENGLISH
Publicidad
