Publicidad
Idiomas disponibles
Idiomas disponibles
STEP 4
1.
Fasten the left handle (17L) to the left swing bar (26L) and the right handle (17R)
to the right swing bar (26R). Secure each connection with 2 he screws (11),
2 spring washers (13), and 2 curved washers (25).
2.
Fasten the left swing bar (26L) to the left pedal arm (41L) and the right swing
bar (26R) to the right pedal arm (41R). Fasten each connection using 1 he
screw (27), 1 he screw (30), and 1 washer (31).
3.
Tighten all screws.
STEP 5
1.
Remove 2 he screws (11) each from the left pedal support (95L) and the right
pedal support (95R).
2.
Fasten the left pedal (43L) to the left pedal support (95L) and the right pedal (43R)
to the right pedal support (95R). Secure each connection using 2 he screws (11).
3.
Tighten all screws.
STEP 6
1.
Remove 2 he screws (11), 2 spring washers (13), and 2 curved washers (12) from
the handlebar post (3). Remove the end cap (14).
2.
Mount the middle handle (4) to handlebar post (3). Secure the connection with
2 he screws (11), 2 spring washers (13), and 2 curved washers (12).
3.
Tighten all screws.
4.
Remove 4 screws (1c) from the back of the computer (1).
5.
Guide the 2 pulse sensor cables (10) on the middle handle (4) through the opening
on the handlebar post (3). onnect the 2 pulse sensor cables on the middle handle
with the 2 pulse sensor cables (1b) on the computer (1). onnect the connection
cable (2) to the connection cable (1a) on the computer. lose the opening on the
handlebar post with 1 end cap (14).
6.
Mount the computer (1) to the handlebar post (3). Fasten it using 4 screws (1c).
7.
onnect the power adapter s barrel connector (44) to the socket on the back of the
frame (40).
STEP 7
There are 2 adjustable feet each on the front stand (32) and the rear stand (49).
•
1.
If the product is not even, turn the adjustable feet (50) clockwise or
counterclockwise to even up the product.
STEP 8
1.
To move the product from one location to another, press the middle handle (4) down
until the transport rollers (34) touch the floor.
2.
Now push the product in this position to the desired location.
56
Publicidad
