Publicidad
Idiomas disponibles
Idiomas disponibles
4. INSTALLATION AND START-UP OF THE MACHINE
4.1 Setting up the machine
Position the machine in a place suitable for its intended use which complies with all mandatory
safety conditions. The area must be equipped with sufficient lighting and aeration.
Position the machine observing the minimum distances from walls, as illustrated in fig. 5, to ensure
there is sufficient space for work, cleaning and routine maintenance operations. This will also allow
operators to work in safe conditions, avoiding any crushing and/or being dragged between the bowl
and the wall. When positioned as above, the machine is stable and does not require anchoring to the
floor.
100 cm
10 cm
4.2 Electrical power supply
The machine is equipped with one single electrical connection with a power cord at the back of the
machine; the system layout can be seen in the diagram supplied with the machine.
Check that the rated plate voltage corresponds to the main network voltage and the rated plate
power is equal or lower than the network power.
The connection must foresee coupling to a manual voltage disconnection switch, to allow the
separation of the electric machine parts from the mains network when necessary (e.g. during
cleaning or maintenance). This device serves to transmit the correct rated current; the diameter of
the main network connection and external protection (earthing) cables must be proportional and
adequate for the rated current.
Attach a retention plug to the end of the machine power cord suitable for the disconnection switch
installed and plug it into the socket.
Start the machine and check that the spiral mixer turns in the direction indicated by the arrow on the
front of the structure below the bowl. If this is not the case, invert the position of the two phase wires
in the plug. The machine does not require any other type of intervention and is now ready to use.
35
25
Publicidad
