Optional Accessories; Pin Assignment - Sony iCY-SHOT DXC-S500 Manual De Instrucciones

Optional accessories

Sony "Memory Stick"
MSA-16AN, MSA-32AN, MSA-64AN, MSA-128A
Memory Stick/PC card adaptor
MSAC-PC2N
Memory Stick reader/writer
MSAC-US1A (compatible with USB)
MSAC-US5 (with mouse function)
1394 cable
VMC-IL6615A (6-pin, 1.5 m)
VMC-IL6635A (6-pin, 3.5 m)
Foot switch
FS-20
40
GB
Specifications

Pin assignment

FS2 connector (D-sub 9-pin)
Inputting the signals to the FS2 connector enables
control of the camera.
The following pins of the FS2 connector are assigned to
each function of the LIVE, CAPTURE and REC buttons
of the camera.
Pin Function
No.
1 When the signal is
input, camera enters
LIVE picture mode.
2 When the signal is
input, picture is
captured in the built-in
frame memory of the
camera with the
specified picture size.
3 When the signal is
input, picture is
recorded on a card.
6 Common ground
connector
Notes
• Inputting two or more signals to the FS2 connector
disables normal operation.
• When using the FS2 connector, set CAPTURE TRIG
to FS2 in the CAPTURE/REC SET UP menu.
(page 19)
3 2 1
6
Signal assignment
Signal should be input for more
than 20 ms and the signal level
should be less than 0.6 V (LOW
level). The signal is pulled up
by 10 kohms inside the camera.
Signal should be input for more
than 20 ms and the signal level
should be less than 0.6 V (LOW
level). The signal is pulled up
by 10 kohms inside the camera.
Signal should be input for more
than 20 ms and the signal level
should be less than 0.6 V (LOW
level). The signal is pulled up
by 10 kohms inside the camera.
Common to the frame ground
on the camera.