Connections For Shooting Using A Flash (Input Mode); Connections For Capturing A Still Picture Using A Foot Switch - Sony iCY-SHOT DXC-S500 Manual De Instrucciones

Connections for Shooting Using a
Flash (INPUT Mode)
The following explains how to connect a slave unit for
synchronizing with a flash.
Slave unit
Camera
head
(rear)
Camera
Synchronization
cable
cable
(supplied)
TRIG
CAMERA
IN
NTSC
CAMERA
PAL
VIDEO
FLASH
IEEE
1394 FS-30 FS-20
OUTPUT REMOTE
Note
When connecting a slave unit for synchronizing with a
flash, set FLASH MODE in the CAMERA SET UP
menu to EXT: INPUT (page 19) and CAPTURE TRIG
to EXT TRIG in the CAPTURE/REC SET UP menu
(page 19).
When you press the LIVE button after setting the above,
the indicator of the button lights in green and the camera
enters standby for flash. Press the LIVE button for each
shot to make the camera standby for flash.
When the camera is in standby mode for flash, the
response of button operation becomes slow. This is not a
malfunction of the camera.
Video monitor,
VTR, etc.
Flash
Video input
connector
75-ohm coaxial cable
Camera control
VIDEO
unit (rear)
OUTPUT
OFF ON
S VIDEO
~ AC IN
TRIG IN
Power cord
Connections for Capturing a Still
Picture Using a Foot Switch
The following explains how to connect an FS-20 foot
switch (not supplied) to capture a picture into the frame
memory of the camera.
Camera head (rear)
Camera cable
(supplied)
VIDEO
CAMERA
OUTPUT
NTSC
CAMERA
PAL
VIDEO
FLASH
IEEE
FS-30 FS-20
1394
OUTPUT REMOTE
FS1
Foot switch
(not supplied)
Note
When connecting the FS-20 foot switch, set CAPTURE
TRIG to FS1 in the CAPTURE/REC SET UP menu
(page 19).
Video monitor, VTR, etc.
Video input
connector
75-ohm coaxial cable
Camera control unit (rear)
OFF ON
S VIDEO
~ AC IN
TRIG IN
Power cord
Connections
33
GB