Assembling The Bearing And Guard - Stihl TS 700 Manual De Instrucciones

Assembling the bearing
and guard
The "bearing with guard" is mounted on
the inboard side of the cast arm by the
manufacturer.
The "bearing with guard" can also be
mounted on the outboard side
depending on requirements.
Assembly on the inboard side is
recommended for freehand cutting on
account of the better balance; outboard
mounting is recommended when the
machine is mounted on a STIHL cut-off
machine cart.
Versions
There are two different deflector
versions (A, B) for the TS 700.
For the TS 800 there is only the
version B.
TS 700, TS 800
Version A (TS 700)
2
Version B (TS 700, TS 800)
Distinguishing features
– Deflector shape (1)
– Adjusting lever shape (2)
Outboard mounting
Version A (TS 700)
N Disassemble the abrasive wheel
(see "Fitting / replacing an abrasive
wheel")
2
N Unscrew the banjo bolt (1)
N Remove the square nut from the
guide from the inboard side of the
guard
N Detach water attachment (2) from
adjusting lever
4
3
N Turn the guard in the direction of the
arrow until the adjusting lever points
forwards
N Undo the banjo bolt (3) and remove
the bolt and washer
N Remove the square nut from the
guide from the inboard side of the
guard
N
Remove screw (4)
N Turn the adjusting lever upwards
and remove
English
1
23