Remote Control; Component Identification (Side-Mount Control Box); Operation - HONDA marine BF40D Instrucciones Del Montaje

7. REMOTE CONTROL

COMPONENT IDENTIFICATION (Side-mount control box)

POWER TRIM/TILT SWITCH
(Equipped type only)
FRICTION ADJUSTING SCREW
CONTROL LEVER ..........................Controls gear selection and throttle opening position.
INDICATOR LIGHT .........................Indicates the operating condition of the outboard motor.
FAST IDLE LEVER ..........................For engine warm-up and throttle opening adjustment when restart the
IGNITION SWITCH .........................For starting and stopping the outboard motor.
EMERGENCY STOP SWITCH .......Will be activated in case of emergency stop, or when the operator falls
FRICTION ADJUSTING SCREW ....Use this screw to adjust the operating resistance of the control lever.
NEUTRAL RELEASE LEVER .........To move the control lever out of the "N" (NEUTRAL) position, lift this lever
POWER TRIM/TILT SWITCH...........Use this switch to tilt up/down and to trim up/down the outboard motor.
(Equipped type only)

OPERATION

• The fast idle lever can be operated provided that the control lever is in the "N" (NEUTRAL) position.
• The engine speed increases with the fast idle lever in the range shown, which promotes warming up of the engine.
• Set the fast idle lever at the "Max." position after warming up and at restart of the engine.
• The control lever can be operated provided that the fast idle lever returned fully to the release position.
55° MAX.
FAST IDLE LEVER
OPERATION RANGE
0° IDLE POSITION
CONTROL LEVER
NEUTRAL RELEASE LEVER
INDICATOR LIGHT
(Engine oil indicator light, overheat warning light, alternator warning light,
PGM-FI warning light)
warm engine.
overboard.
up.
F (FORWARD)
ENGINE RUNNING
FULL OPEN POSITION
25
FAST IDLE LEVER
IGNITION SWITCH
EMERGENCY STOP SWITCH
N (NEUTRAL)
30°
30°
R (REVERSE)
ENGINE RUNNING