HONDA marine BF40D Instrucciones Del Montaje página 32

7) Install the neutral lock block on the control
housing B and tighten the two 6 x 16 mm self-
tapping screws.
Torque: 2.5 N·m (0.25 kgf·m, 1.8 lbf·ft)
CONTROL HOUSING B
8) Install the control lever to the remote control box.
• Install the control lever by setting it in the "N"
(Neutral) position.
CONTROL LEVER
WIRE HARNESS
9) Connect the power trim/tilt switch wire harness
connectors.
10) Route the power trim/tilt switch wire harness as
shown. Install the power tilt cord clamp and
tighten the two 5 x 8 mm self-tapping screws.
Torque: 0.69 N·m (0.07 kgf·m, 0.5 lbf·ft)
HANGER
HARNESS
5 x 8 mm SELF-TAPPING
SCREW (2)
TAPE END
11) Tighten the housing cover C with the two
NEUTRAL LOCK BLOCK
6 x 16 mm SELF-
TAPPING SCREWS
12) Install the remote control lever and tighten with
GROMMET A
POWER TILT
CORD CLAMP
CONNECTORS
30
5 x 25 mm self-tapping screws .
Torque: 2.5 N·m (0.25 kgf·m, 1.8 lbf·ft)
• Set the grommet A by aligning it with the cutout
in the control housing B and housing cover C.
• Do not overtighten the screws.
5 x 25 mm SELF-TAPPING
SCREW (2)
HOUSING COVER C
GROMMET A
CONTROL HOUSING B
the 8 x 35 mm flange bolt using 12 mm socket.
Torque: 23.5 N·m (2.4 kgf·m, 17 lbf·ft)
CONTROL LEVER
(at neutral position)
8 x 35 mm FLANGE BOLT
CONTROL HOUSING B
SWITCH WIRE
HARNESS
HOUSING COVER C