Wiring Diagram - HONDA marine BF40D Instrucciones Del Montaje

Meter Wire Harness Connection
Connect the wire harness properly, as shown in the

wiring diagram.

Use Meter Wire Harness A and B for meter.
• Make sure insulators surround their connectors
completely and that the ends are not folded up.
• Do not break the wire harness coverings. If the
covering of a wire is broken, either repair it with
electrician's tape or replace it.
• Attach unused terminals to the adjacent main
harness with a piece of vinyl tape so that the
terminals don't interfere with the surrounding parts.
• Connect each wire properly as shown in the wiring
diagram. After each wire and harness is connected,
check for proper connection by referring to the
wiring diagram.
• Connect the battery and turn the main power on to
check for proper operation.
WIRING DIAGRAM
TACHOMETER
LIGHTING
SWITCH
METER WIRE HARNESS A
This is an independent engine-control system. Do
not attempt to integrate it with the boat's system or
other accessories, except for the instrument light
switch.
There are three ways to illuminate the instrument
lights:
• Connect a commercially available switch (Teleflex
1A 16970 or equivalent) between the Bl/Y and R/W
terminals.
• Connect 12V (+) from the boat's instrument lights
to the R/W terminal.
• Connect the Bl/Y and R/W terminals together for
"lights on" with the engine switch.
TRIM METER
HOUR METER
R/W R/W
Bl Bl
Bl/Y Y
METER WIRE HARNESS B
Lg/Bl Lg/Bl
Bl Bl
Y/Bu Y/Bu to TILLER HANDLE or
Bl/Y Bl/Y
REMOTE CONTROL BOX
10A
Gr Gr
44
SPEEDOMETER
VOLT METER
R/W R/W
Bl Bl