HONDA marine BF40D Instrucciones Del Montaje página 36

1) Install the lock nut and shift pivot on each control
cable.
• Set each shift pivot at the position 5 mm (0.2 in)
or more from the cable end as shown.
• Apply the marine grease to the pivot pins.
CONTROL CABLE
LOCK NUT
(Marine grease)
5 mm (0.2 in) OR MORE
2) Pass the starter cable, switch panel cable and
indicator cord through the under case grommet A,
and install them in the outboard motor.
3) Set the harness band clip on the clip bracket and
clamp the switch panel cable and indicator cord
with the harness band clip.
4) Connect the connectors to the main wire harness
and set them on the holders.
INDICATOR CORD HOLDERS
SWITCH PANEL
CABLE
HARNESS BAND CLIP
UNDER CASE
GROMMET A
SHIFT CONTROL CABLE
THROTTLE CONTROL CABLE
SWITCH PANEL CABLE
INDICATOR CORD
STARTER CABLE
Viewed from out side
5) Install the control cable set plate in the groove of
6) Pass the throttle and shift control cables through
THROTTLE CONTROL
CABLE
SHIFT PIVOT
CONTROL CABLE
SET PLATE
7) Install the separator cover with the 6 x 28 mm
6 x 28 mm FLANGE BOLT (2)
MAIN WIRE HARNESS
STARTER
CABLE
6 mm WASHER (2)
34
the under case.
the under case grommet A, and set them to the
control cable set plate by aligning the groove with
the cutouts in the control cable set plate.
SHIFT CONTROL CABLE
UNDER CASE GROMMET A
flange bolts, 6 x 40 mm hex. bolts and 6 mm
washers.
SEPARATOR COVER
6 x 40 mm HEX. BOLT (2)