Installation - HONDA marine BF40D Instrucciones Del Montaje

INSTALLATION

• Remove the switch clip of the emergency stop
switch to prevent the engine from starting
accidentally.
• Wear heavy gloves to protect your hands from
sharp or nicked propeller blades.
MARINE GREASE
GEAR CASE
1) Apply marine grease to the propeller shaft.
2) Install the thrust collar with the groove facing to
the gear case, and install the propeller on the
propeller shaft.
3) Install the 10 mm spacer, 17 mm washer and
16 mm castle nut.
4) Tighten the castle nut with your hand first until the
propeller has no play. Then, tighten the castle nut
again with a tool until the groove in the castle nut
aligns with the pin hole.
Minimum torque: 1.0 N·m (0.1 kgf·m, 0.7 lbf·ft)
5) Install the 4 mm cotter pin.
If the cotter pin does not align with the hole in the
propeller shaft, adjust by turning the nut in the
tightening direction.
• Do not exceed the maximum torque.
Maximum torque: 35 N·m (3.5 kgf·m, 25 lbf·ft)
THRUST WASHER
PROPELLER
16 mm CASTLE NUT
10 mm SPACER
17 mm WASHER
6) After installation, bend the split pin ends as
shown to secure.
• Always use the genuine Honda or Honda
recommended part (stainless steel).
51
4 mm COTTER PIN
4 mm COTTER PIN