Adjusting The Throttle Control Cables (F6Amh/F6Mh, F6Bmh, F8Cmh/F8Mh) - Yamaha F6AMH Manual De Servicio

CONTROL SYSTEM
ADJUSTING THE THROTTLE CONTROL
CABLES (F6AMH/F6MH, F6BMH,
F8CMH/F8MH)
NOTE:
Before adjusting the throttle control cables,
make sure that the shift control cable is
properly adjusted (for long handle model
only)
1. Check:
Throttle control cables


Damage
Excessive slack or the stoppers do
not contact each other
2. Adjust:
Throttle control cables


Adjusting steps:
(1)Turn the throttle grip to the fully-
opened position.
(2)Loosen the locknut 1.
(3)Adjust the length of the throttle wire 2
with the adjusting nut 3 until the
stopper portion
contacts the stopper portion
throttle wire stay 5.
(4)Tighten the locknut 1.
(5)Loosen locknut 6.
(6)Adjust the length of the throttle wire 7
with the adjusting nut 8.
NOTE:
Adjust the length so that there is no
clearance between the drum hole of pulley
4 and the drum at the tip of decelerator
cable 7.
(7)Tighten the locknut 6.
(8)Fully open and close the throttle grip
and make sure the stopper portion
contacts the stopper portion
fully opened position), and the stopper
c
portion contacts the stopper portion
d
(at the fully-closed position).
If proper contact is not made, repeat
the above procedure.
3-6
Replace.

Adjust.

a
on the pulley 4
b
b
on the
a
(at the