Bianchi Reparto Corse Manual De Instrucciones página 92

If the problem persists, rotate the cable screw once again for a
complete turn. If the problem still not solved, have your bicycle
checked by a specialist Dealer.
For any doubt or problem with the operation of these components,
Bianchi invites you to read the relevant manuals enclosed with the
bicycle.
CHECK
CHECK
THE WEAR OF
THE WEAR
T BRAKE PADS,
AND ADJUST
ADJUST AND
THE PLAY OF
THE HEAD SET REPLACE IF
NECESSARY
Brakes
If the brake lever has excessive
travel, calibrate it by turning the
brake cable adjustment screw,
then lock it in position by fi rmly
tightening the adjusting barrel.
If the lever travel is still
excessive, have it checked out
by a specialist Dealer.
Rear derailleur and chain
If the chain moves from one
gear to another with diffi culty,
the rear derailleur is not
adjusted properly.
The cause may simply be a
loosened cable.
In this case, rotate
adjustment screw of said
cable counterclockwise by a
half a turn.
Afterwards, try to operate the
rear derailleur and see if there
is an improvement.
CHECK CHECK
AND ADJUST THE PLAY AND THE PLAY /
THE PLAY ADJUSTMENT LOCKING OF
OF BRAKE OF THE BRAKE THE BB SET
CABLES LEVERS AND PEDAL
AND OUTER ASSEMBLY
SCREWS
CABLES
CLEANING YOUR BICYCLE
Your new Reparto Corse bicycle must be kept clean, especially if
subjected to frequent use.
Bianchi recommends that you carry out periodical cleaning at
regular intervals, and that you clean the bicycle right after using it
on dirt roads or on dusty, muddy or wet grounds.
Lubrication
WARNING / IMPORTANT:
Y our new Reparto Corse bicycle must be lubricated correctly and
regularly according to the environmental conditions, the climate
and the type of use it is subjected to.
Bianchi invites you to contact your specialist Dealer for instructions
on the recommended frequency and on the most suitable
lubricants.
After careful cleaning, Bianchi advises you to lubricate the gears,
the
the teeth of the freewheel, the small connecting rods and the
derailleur pulleys, the shifters, the brake levers, the brake pins and
the chain, always removing any excess lubricant.
Bianchi recommends using specifi c cycling lubricants only and to
avoid excessively thick lubricants (such as engine oil and similar).
WARNING / IMPORTANT:
A true cyclist always respects the environment.
To avoid any type of pollution, Bianchi invites you to avoid
abandoning your bike or parts of it, as well as dispersing lubricants
or other consumables in the environment.
CHECK MAKE SURE
CHECK THE
ALL
FASTENING
HANDLEBAR
OF THE SEAT
SCREWS ARE
POST TO THE
FRAME AND PROPERLY
OF THE SEAT TIGHTENED
TO THE SEAT
POST
ENGLISH
MAKE SURE VISUALLY
ALL THE OPTI- CHECK FOR
CAL/ACOUSTIC ANY CRACKS FRONT / REAR
SIGNALS OR FLAWS IN SUSPENSION
WORK PRO- THE FRAME
PERLY AND IN THE
FORK
CHECK
THE
91