Publicidad
Idiomas disponibles
Idiomas disponibles
EN
Position the columns on the inner side and secure them to the beam
using the M6x20 countersunk screws.
5.2 - Fixing
The following figures illustrate the layout of automation fastening
on the wall.
48
Max screw diameter Ø 4.2 mm
Coupling bracket
3,5 max
6,5 max
Take the telescopic beam profile and insert the M6 square nuts from
the side of the round belt fixing block ("Lbl" dimension) and the "L"
bracket into the appropriate slot, positioning them as indicated in the
installation diagrams. Preserve their position by tightening the screws.
Lbl
The coupling bracket can be used to facilitate the assembly of the
automation. It is advisable to fix the central screw first and then the
side screws so that the beam can be levelled correctly. Screws with
a head height not exceeding 3.5 mm and a maximum diameter of
4.2 mm must be used to fix the coupling profile. Drill the beam at the
appropriate notch as shown in the figure below.
40 mm
Reference mark for the
wall fixing holes
Publicidad
