Publicidad
Idiomas disponibles
Idiomas disponibles
6.6 - Ancoraggio e preparazione anta lenta
7.2 - Inserting the panel on the front beam
Before inserting the panel on the beam, the anti-derailment wheels
of the runners must be free. Then loosen the screws shown in the
figure below and remove any belt anchoring brackets present.
At this point it is possible to connect the panel to the beam.
7.3 - Positioning of the runner between the panels (900LEV8)
6.6 - Ancoraggio e preparazione anta lenta
Take the runner support bracket and align the two positioning
notches to the lower profile of the slow panel and the side edge
to the edge of the slow panel, from the overlapping part with the
fast panel.
Floor guide integrated
in the panel
Floor guide outside the
panel
Take the runner and find the correct position for the distance of the
two panels. The holes on the runner are outside the centreline to
allow greater adjustment, in addition to that given by the holes on
the bracket.
Once the panel is connected to the beam, push the anti-derailment
wheels upwards and lock them.
N.B. It is advisable not to lock the anti-derailment wheel directly
in contact with the upper part of the beam profile, but to leave
approximately 0.5÷1 mm of space between the wheel and the beam.
Once the correct position has been identified, lock the position with
the screws from below the bracket.
Alignment
notches
Secure everything to the slow panel with screws (not included in
the kit) in the position previously identified.
Alignment
notches
EN
Floor guide
integrated in the
panel
Floor guide
outside the panel
57
Publicidad
