Franke COUNTRY CL 85 M Manual De Instalación Y Servicio página 15

Cleaning the oven door
X
The oven door must be cleaned (internally
and externally) when the oven is completely
cold, using hot water. Do not use abrasive
cloths. Clean the glass using special
detergents.
X
Clean the enamelled surfaces with
hot water and non-abrasive detergent, just
as for the oven interior itself.
Removing the oven door internal glass
(models CL only) (Fig. 2)
The glasses of the oven door can be removed
to enable thorough cleaning of the internal
glasses, by proceeding as follows:
X
With the door completely open, turn the two
black blocks (with the word „CLEAN")
at the bottom of the door 180° so that they
fit into the seats in the oven structure.
Note: Make sure you turn them fully
(the blocks will click into this position).
X
Carefully lift the internal glasses: the two
blocks will prevent the door from closing (if
the blocks are not turned fully, removing the
glasses will cause immediate closing of the
door).
X
After carrying out the cleaning operations,
refit the internal glasses (the correct
position is indicated by the words
„TEMPERED GLASS" which must
be perfectly legible) and turn the two glass
retaining blocks back to their original
position.
Never try closing the door when only
one or both blocks have partially or completely
freed the internal glass panels. After cleaning,
always remember to turn both blocks before
closing the door.
Removing the oven door internal glass
(models CM only) (Fig. 3)
The glass of the oven door can be removed
to enable thorough cleaning of the internal
glass, by proceeding as follows:
X
With the door completely open, turn the two
black blocks at the bottom of the door 180°
(Fig. 3a and 3b).
CL 85 M / CM 85 M
Note: Make sure you turn them fully
(the blocks will click into this position).
X
Carefully lift the internal glass (Fig. 3c):
the two blocks will prevent the door from
closing (if the blocks are not turned fully,
removing the glass will cause immediate
closing of the door).
X
To remove the glass in between, slide out
the two side gaskets (Fig. 3d) and then lift
out the glass (Fig. 3e).
X
After carrying out the cleaning operations,
refit the intermediate glass (Fig. 3f)
(the correct position is indicated
by the wording „TEMPERED GLASS" which
must be perfectly legible) by inserting
it carefully into the relevant grooves located
at the top of the door and pushing it all the
way to the end of the groove.
X
Then replace both gaskets (Fig. 3g), taking
extra care to ensure they are inserted as
far as possible, until they come into contact
with the upper edge of the door.
X
Finally, refit the internal glass (Fig. 3h) and
turn the two glass retaining blocks back
to their original locking position.
Never try closing the door when only
one or both blocks have partially or completely
freed the internal glass panels. After cleaning,
always remember to turn both blocks before
closing the door.
Removing the oven door (Fig. 4a, 4b, 4c)
To facilitate oven cleaning, the oven door
can be removed by operating on the hinges
as follows:
X
The hinges are equipped with two moveable
locks (A). Lift the lock (A) to release the
hinge.
X
Then lift the door up and pull it outwards; to
do this, hold the door at the sides near the
hinges.
X
To refit the door, first slide the hinges into
their grooves.
X
Before closing the door, remember
to turn the two locks (A) used as hinge
attachments.
Refer to the pictures at the end of this manual.
– 15 –
EN