Franke COUNTRY CL 85 M Manual De Instalación Y Servicio página 16

EN
Removing the side frames
X
Bend the crosspiece engaged in the fixing
bush downwards and remove it from
the groove.
X
Tilt the frame upwards by approx. 60° and
push it slightly in the direction of inclination.
X
Keeping the frame tilted, remove the two
top hooks from the respective holes.
Fitting the side frames
X
Keeping the frame tilted, insert the top
hooks in the respective holes, pushing
lightly in the direction of inclination.
X
With the frame tilted, pull in the direction of
inclination until the top hooks stop against
the outside of the compartment wall.
X
Turn the frame towards the compartment
wall. Bend the crosspiece engaged
in the fixing bush downwards and remove
it from the groove.
Replacing the oven lamp
A
X
Turn off the power to the appliance
by means of the omnipolar switch used
for connecting it to the electrical system,
or disconnect the plug if accessible.
X
Unscrew the glass cover (A).
3
2
1
Franke ovens are
equipped with
a circular lamp
positioned in the top
left area at the back
of the compartment.
To replace the oven
lamp, proceed as
follows:
CL 85 M / CM 85 M
X
Unscrew the lamp and replace it with one
resistant to high temperatures (300 °C),
with the following characteristics:
– Voltage: 220/240 V ~ 50-60 Hz
– Power: 25 W
– Connection: G9
X
Refit the glass cover (A) and reconnect
the power supply.
Caution! Damage to the lamp due to wrong
handling!
Z
Avoid touching the lamps with bare hands.
Z
Use a cloth or a sheet of kitchen paper.
WARNING! Possibility of electric
shock!
Ensure that the oven is switched off before
replacing the lamp.
WARNING! Electric shock
due to wrong handling!
Z
Switch the oven off.
– Depending on how the oven is installed:
Unplug the oven or disconnect the power
at the main electrical system switch, e.g.,
switch off the fuse of the oven in the fuse
box.
– 16 –