Publicidad
Idiomas disponibles
Idiomas disponibles
Preparation
Installing the PIONEER speaker
(PDP-5072HD/PDP-5071HD/PDP-5070HD)
CAUTION
• If you want to move the Plasma Display unit, make sure that
you remove the speaker first. In addition, do not move the
display holding on to the mounting fittings. This can result in
injury or damage to the unit.
About the speaker
• In order to prevent damage to the speaker system resulting
from input overload, please observe the following
precautions:
• Do not use the speaker with anything other than the
Plasma Display. Doing so may result in damage or fire.
• Be sure to turn the connected devices off and remove
the power cord from the power outlet beforehand when
changing the connection or installation method.
• When using a tone control function to greatly
emphasize treble sounds, do not use excessive amplifier
volume.
• Please handle the speaker with sufficient care, as the grille
net and the cabinet can become damaged or broken when
they are subjected to strong external impacts.
• Placing a CRT computer screen or CRT monitor near to the
speaker may result in interference or color distortion. If this
happens, distance the monitor from the speaker.
PDP-5072HD/PDP-5071HD/PDP-5070HD with the speaker installed
(with the PIONEER table top stand)
Speaker mounting
screw (M5 x 10 mm)
Speaker mounting
screw (M5 x 10 mm)
Speaker mounting fitting
(right side)
Installation
• The speaker is wide, and may become unstable when
installed by a one person alone. This may result in injury or
product damage. Therefore, at least two people must
assemble and install it.
• When installing the speaker, do not use any screws other
than those supplied, otherwise the speaker may come off
from the main unit and fall over.
• When installing the speaker, tighten the screws firmly.
• Be sure to turn the connected devices off and remove the
power cord from the power outlet beforehand when
changing the connection or installation method.
NOTE
• Before installing the speaker, make sure that the PIONEER
table top stand is attached to the Plasma Display.
Speaker mounting
screw (M5 x 10 mm)
Speaker mounting fitting
(center)
Speaker cable
Speaker mounting
screw (M5 x 10 mm)
Speaker mounting
screw (M5 x 10 mm)
Speaker
Speaker mounting fitting
(left side)
05
21
En
Publicidad
