Publicidad
Idiomas disponibles
Idiomas disponibles
Useful Remote Control Features
Useful Remote Control Features
Presetting manufacturer codes to
control other devices
Presetting manufacturer codes
1
Slide the Mode switch to match the device to which you
want to preset the remote control signal.
2
Press EDIT and 1 at the same time.
• The LED flashes.
3
Press 0 – 9 to enter the manufacturer code. See page 82.
• Preset mode is finished once the LED no longer lights
up.
Library Search
In the event that the device code for a particular target unit is
unknown, you can cycle the remote through the available
codes for that device mode and sample functions from each
code in order to find the code that properly operates the
desired target device.
1
Slide the Mode switch to match the device to which you
want to preset the remote control signal.
2
Press EDIT and 3 at the same time.
• The LED indicator flashes and the remote control unit
enters the Library Search programming mode.
3
Press either SOURCE POWER, PLAY, 1 or CH+ to sample
the selected code.
4
When the code could not be found, press
to the next code or return to the previous code and repeat
step 3.
5
Press ENTER when the code that properly operates the
desired target device is found.
• All the available buttons for the selected mode are
programmed in. The remote control unit returns to
normal operation after turning the LED indicator on for
one second for confirmation.
Manufacturing Reset
You can reset all the learned and preset codes to default
regardless of the mode.
1
Press EDIT and POWER in any Mode switch position at
the same time.
• The LED indicator flashes and the remote control unit
enters the Manufacturing Reset mode.
2
Press D.
• A manufacturing reset is completed. The LED indicator
flashes for one second and the remote control unit
returns to normal operation.
NOTE
• To exit the Edit mode before it is complete, press EDIT again.
• If the Mode switch selection is changed when in the Edit
mode, the Edit mode is canceled.
• If no operation is performed for more than one minute, the
Edit mode is canceled.
• When you enter a code not listed, the LED flashes quickly.
• The initial mode is "PIONEER".
/
to advance
13
81
En
Publicidad
