Pioneer PureVision PDP-6072 Manual De Instrucciones página 72

Enjoying through External Equipment
12
Using HDMI Input
The INPUT 5 and INPUT 6 terminals are HDMI terminals to
which digital video and audio signals can be input. To use the
HDMI terminal, specify the types of video and audio signals to
be received from the connected equipment. For the types of
these signals, see the operation manual that came with the
connected equipment.
Before starting the menu, press INPUT 5 (or INPUT 6) on the
remote control unit or press INPUT on the Plasma Display to
select INPUT 5 (or INPUT 6).
Input signal correlation table
19201080i@59.94/60Hz
720480p@59.94/60Hz
1280720p@59.94/60Hz
720(1440)480i@59.94/60Hz
19201080p@24Hz
For audio, the system supports the following:
• Linear PCM (STEREO 2ch)
• Sampling frequency: 32 kHz, 44.1 kHz, 48 kHz
NOTE
• PC signals are not supported.
• It may take time until an image is displayed depending on the
equipment connected.
Connecting HDMI equipment
Plasma Display (rear view)
Audio cable
(commercially available)
Make this connection
when inputting analog
audio signals.
72
En
Viewed from below of
the Plasma Display
HDMI cable having the
HDMI mark
(commercially available)
HDMI equipment
To specify the type of digital video signals:
1
Press HOME MENU.
2
then ENTER)
Select "Option". ( /
3
Select "HDMI Input". ( /
4
then ENTER)
Select "Video". ( /
5
Select the type of digital video signals. ( /
• If you select "Auto", an attempt will be made to identify
the type of digital video signals when digital video
signals are received.
Item Description
Auto
Automatically identifies input digital video signals.
(factory default)
Color-1
Digital Component Video signals (4:2:2) locked
Color-2 Digital Component Video signals (4:4:4) locked
Color-3 Digital RGB signals locked
6
Press HOME MENU to exit the menu.
NOTE
• If you select a parameter other than "Auto", make such a
setting that results in natural color.
• If no image appears, specify another digital video signal type.
• For the digital video signal types to be specified, check the
operation manual that came with the connected equipment.
To specify the type of audio signals:
1
Press HOME MENU.
2
then ENTER)
Select "Option". ( /
3
Select "HDMI Input". ( /
4
then ENTER)
Select "Audio". ( /
5
Select the type of audio signals. ( /
• If you select "Auto", an attempt will be made to identify
the type of audio signals when audio signals are
received.
Item Description
Auto Automatically identifies input audio signals.
(factory default)
Digital Accepts digital audio signals.
Analog Accepts analog audio signals.
6
Press HOME MENU to exit the menu.
NOTE
• If no sound is output, specify another audio signal type.
• For the audio signal types to be specified, check the
operation manual that came with the connected equipment.
• Depending on the equipment to be connected, you also need
to connect analog audio cables.
then ENTER)
then ENTER)
then ENTER)
then ENTER)